The Laddermill: Innovative Wind Energy from High Altitudes in Holland and Australia

The Laddermill is a novel concept to harvest electricity from high altitude winds. The concept's operating principle is to drive an electric generator using tethered kites. Several kites are deployed to altitudes of more than 1 km by means of a single cable that is connected to a drum on the groundstation. The upper portion of the cable is...

Two-Degree-of-Freedom Active Vibration Control of a Prototyped “Smart” Rotor

This paper studies the load reduction potential of a prototyped “smart” rotor. This is, a rotor where the blades are equipped with a number of control devices that locally change the lift profile on the blade, combined with appropriate sensors and controllers. Experimental models, using dedicated system identification techniques, are developed...

Kite and classical rig sailing performance comparison on a one design keel boat

A Review of Methods to Increase the Availability of Wind Turbine Generator Systems

Availability is an important factor to be considered when designing wind turbine generator systems. The quest for increasing availability is based on the following five design approaches - design for component reliability, active control for reliability, design for fault tolerance, prognostics, and design for maintainability. This paper reviews...

Assessing the Severity of Wind Gusts with Lidar

Lidars have gained a lot of popularity in the field of wind energy, partly because of their potential to be used for wind turbine control. By scanning the oncoming wind field, any threats such as gusts can be detected early and high loads can be avoided by taking preventive actions. Unfortunately, lidars suffer from some inherent weaknesses that...

Comparison of levelized cost of energy of superconducting direct drive generators for a 10-MW offshore wind turbine

A method for comparing the levelized cost of energy (LCoE) of different superconducting drive trains is introduced. The properties of a 10-MW MgB₂ superconducting direct-drive generator and the cost break down of the nacelle components are presented and scaled up to a turbine with a rotor diameter of up to 280 m. The partial load...

Prospective challenges in the experimentation of the rain erosion on the leading edge of wind turbine blades

Developments in the wind industry reveal intricate engineering challenges, one of them being the erosion on the leading edge of the wind turbine blades. In this review work, the main issues for the wind industry in the experimentation with respect to erosion are examined. After a historical and general overview of erosion, this review focuses...

Energy production benefits by wind and wave energies for the autonomous system of Crete

At autonomous electricity grids Renewable Energy (RE) contributes significantly to energy production. Offshore resources benefit from higher energy density, smaller visual impacts, and higher availability levels. Offshore locations at the West of Crete obtain wind availability ≈80%, combining this with the installation potential for large scale...

Mitigating a century of European renewable variability with transmission and informed siting

To reach its goal of net greenhouse gas neutrality by 2050, the European Union seeks to massively expand wind and solar power. Relying on weather-dependent power generation, however, poses substantial risks if climate variability is not adequately understood and accounted for in energy system design. Here we quantify European wind and solar...

A probabilistic long-term framework for site-specific erosion analysis of wind turbine blades: A case study of 31 Dutch sites

Rain-induced leading-edge erosion (LEE) of wind turbine blades (WTBs) is associated with high repair and maintenance costs. The effects of LEE can be triggered in less than 1 to 2 years for some wind turbine sites, whereas it may take several years for others. In addition, the growth of erosion may also differ for different blades and...

Methodology for the energetic characterisation of rain erosion on wind turbine blades using meteorological data: A case study for The Netherlands

Rain erosion on the leading edge of wind turbine blades is an intricate engineering challenge for the wind industry. Based on an energetic approach, this work proposes a methodology to characterise the erosion capacity of the raindrop impacts onto the leading edge blades. This methodology can be used with meteorological data from public...

Mesoscale modeling of a “Dunkelflaute” event

In the near future, wind and solar generation are projected to play an increasingly important role in Europe's energy sector. With such fast-growing renewable energy development, the presence of simultaneous calm wind and overcast conditions could cause significant shortfalls in production with potentially serious consequences for system...

Contentious governance of wind energy planning: strategic dilemmas in collaborative resistance by local governments and citizen action groups

Local governments are at the heart of implementing increasingly ambitious national plans for wind energy. While support by local governments for these plans has been studied extensively, only few studies have looked into local governments’ contestation of wind energy development. In this paper we analyze contentious governance processes in which...

Enabling Co-Innovation for a Successful Digital Transformation in Wind Energy Using a New Digital Ecosystem and a Fault Detection Case Study

In the next decade, further digitalisation of the entire wind energy project lifecycle is expected to be a major driver for reducing project costs and risks. In this paper, a literature review on the challenges related to implementation of digitalisation in the wind energy industry is first carried out, showing that there is a strong need for...

Renewable Energy Potential for Micro-Grid at Hvide Sande

Decarbonization of ports is a major goal to reduce their global carbon footprint. The port of Hvide Sande is located on the coast of the North Sea in Denmark and it has the potential to utilize various renewable energy sources. Wind and solar thermal parks are already installed there. Wave energy is an alternative to solar and wind energies and...