Searched for: +
(1 - 20 of 27)

Pages

document
Sun, Q. (author), Wang, Y. (author), Yang, J. (author), Qiu, Y. (author), Zhang, H. (author)
This paper presents a method to control chaotic behavior of a typical Smart Grid based on generalized fuzzy hyperbolic model (GFHM). As more and more distributed generations (DG) are incorporated into the Smart Grid, the chaotic behavior occurs increasingly. To verify the behavior, a dynamic model which describes a power system with DG is...
journal article 2014
document
Liu, Yang (author), Zhang, H. (author), Wang, Lingen (author), Fan, Xuejun (author), Zhang, Kouchi (author), Sun, Fenglian (author)
The microstructure, thickness, porosity, and shear performance of the silver (Ag) sintering layers under different sintering pressures were investigated. Experimental results demonstrated that the thickness and the porosity of the sintering layer decreased when the sintering pressure varied from 5 MPa to 30 MPa. This densification phenomenon...
journal article 2018
document
Zhang, H. (author), Liu, Yang (author), Wang, Lingen (author), Fan, Jiajie (author), Fan, Xuejun (author), Sun, Fenglian (author), Zhang, Kouchi (author)
High reliable packaging materials are needed for electronics when they work at harsh environments. Among which, the nanosilver material has been widely studied and applied in power electronics due to its low processing temperature and high reliability. This paper investigates the bonding properties of nanosilver sintered hermetic cavity. There...
journal article 2018
document
Santagata, F. (author), Sun, J. (author), Iervolino, E. (author), Yu, H. (author), Wang, F. (author), Zhang, Kouchi (author), Sarro, Pasqualina M (author), Zhang, Guoyi (author)
Purpose: The purpose of this paper is to demonstrate a novel 3D system-in-package (SiP) approach. This new packaging approach is based on stacked silicon submount technology. As demonstrators, a smart lighting module and a sensor systems were successfully developed by using the fabrication and assembly process described in this paper. Design...
journal article 2018
document
Sun, J. (author), Zhan, Teng (author), Liu, Zewen (author), Wang, Junxi (author), Yi, Xiaoyan (author), Sarro, Pasqualina M (author), Zhang, Kouchi (author)
This paper demonstrates a method to reduce the decay time in AlGaN/GaN photodetectors by a pulsed heating mode. A suspended AlGaN/GaN heterostructure photodetector integrated with a micro-heater is fabricated and characterized under ultraviolet illumination. We have observed that the course of persistent photoconductivity was effectively...
journal article 2019
document
Sun, Y. (author), Kang, Xuanwu (author), Zheng, Yingkui (author), Lu, Jiang (author), Tian, Xiaoli (author), Wei, Ke (author), Wu, Hao (author), Wang, Wenbo (author), Liu, Xinyu (author), Zhang, Kouchi (author)
Gallium nitride (GaN)-based vertical power Schottky barrier diode (SBD) has demonstrated outstanding features in high-frequency and high-power applications. This paper reviews recent progress on GaN-based vertical power SBDs, including the following sections. First, the benchmark for GaN vertical SBDs with different substrates (Si, sapphire, and...
review 2019
document
Zhang, H. (author), Liu, Y. (author), Wang, Lingen (author), Sun, Fenglian (author), Fan, Jiajie (author), Placette, Mark D. (author), Fan, Xuejun (author), Zhang, Kouchi (author)
Modern power electronics has the increased demands in current density and high-temperature reliability. However, these performance factors are limited due to the die attach materials used to affix power dies microchips to electric circuitry. Although several die attach materials and methods exist, nanosilver sintering technology has received...
journal article 2019
document
Liu, Y. (author), Zhang, H. (author), Wang, Lingen (author), Fan, Xuejun (author), Zhang, Kouchi (author), Sun, Fenglian (author)
Purpose: Crack and stress distribution on dies are key issues for the pressure-assisted sintering bonding of power modules. The purpose of this research is to build a relationship among stress distributions, sintering sequences and sintering pressures during the sintering processes. Design/methodology/approach: Three sintering sequences, S(a)...
journal article 2019
document
Sun, J. (author), Zhan, Teng (author), Liu, Zewen (author), Wang, Junxi (author), Yi, Xiaoyan (author), Sarro, Pasqualina M (author), Zhang, Kouchi (author)
A suspended WO<sub>3</sub>-gate AlGaN/GaN heterostructure photodetector integrated with a micro-heater is micro-fabricated and characterized for ultraviolet photo detection. The transient optical characteristics of the photodetector at different temperatures are studied. The 2DEG-based photodetector shows a recovery (170 s) time under 240 nm...
journal article 2019
document
Zhang, H. (author), Liu, Y. (author), Wang, Lingen (author), Sun, Fenglian (author), Fan, Xuejun (author), Zhang, Kouchi (author)
The nanoindentation test was conducted in this paper to investigate the indentation hardness, plasticity and initial creep properties of pressure sintered nanosilver joint at various test temperatures. The effects of strain rate on the indentation hardness were first investigated. Then yield stress of nanosilver sintered joint was studied in...
journal article 2019
document
Sun, Y. (author), Kang, Xuanwu (author), Zheng, Yingkui (author), Wei, Ke (author), Li, Pengfei (author), Wang, Wenbo (author), Liu, Xinyu (author), Zhang, Kouchi (author)
The optimization of mesa etch for a quasi-vertical gallium nitride (GaN) Schottky barrier diode (SBD) by inductively coupled plasma (ICP) etching was comprehensively investigated in this work, including selection of the etching mask, ICP power, radio frequency (RF) power, ratio of mixed gas, flow rate, and chamber pressure, etc. In particular...
journal article 2020
document
Sun, J. (author), Zhang, Shuo (author), Zhan, Teng (author), Liu, Zewen (author), Wang, Junxi (author), Yi, Xiaoyan (author), Li, Jinmin (author), Sarro, Pasqualina M (author), Zhang, Kouchi (author)
A high responsivity and controllable recovery ultraviolet (UV) photodetector based on a tungsten oxide (WO<sub>3</sub>) gate AlGaN/GaN heterostructure with an integrated micro-heater is reported for the first time. The WO<sub>3</sub>nanolayer was deposited by physical vapor deposition (PVD) for deep UV absorption and the micro-heater was...
journal article 2020
document
Li, Huajian (author), Sun, Deyi (author), Wang, Zhen (author), Huang, Fali (author), Yi, Zhonglai (author), Yang, Zhengxian (author), Zhang, Y. (author)
Pumping is the most common technique used to transport fresh concrete in construction sites. The large-scale use of concrete all over the world makes the pumping increasingly important. A wide variety of additives and admixtures are incorporated into modern concrete in order for sustainable development. The performance of modern concrete is...
journal article 2020
document
Ren, Jie (author), Sun, Hongfang (author), Li, Qun (author), Li, Z. (author), Ling, Li (author), Zhang, Xiaogang (author), Wang, Yanshuai (author), Xing, Feng (author)
One-part alkali-activated slag (AAS) binders are more promising in large-scale constructions because one-part mixing procedure is safer and easier to handle compared to normal two-part method. Thus, this study aims at investigating different properties of one-part AAS binders and control samples prepared using the two-part method. Experimental...
journal article 2021
document
Ying, Shen (author), Sun, Hanrui (author), Li, Chengpeng (author), Zhang, Wenting (author), Wang, Meng (author), Zhan, Yong (author), Zhang, Yu (author), Chen, Xueye (author)
Many immigrants from rural areas pour into urban areas, especially in China, and urban development faces the challenges to provide sufficient space for citizens’ acommodation, works and social contacts. So 3D development and use of land and city space become the reality with various complex buildings and constructions with modern architecture...
conference paper 2021
document
Wang, Kai (author), Xue, Yu (author), Xu, Hao (author), Huang, Lianzhong (author), Ma, Ranqi (author), Zhang, Peng (author), Jiang, X. (author), Yuan, Yupeng (author), Negenborn, R.R. (author), Sun, Peiting (author)
Wing-diesel engine-powered hybrid ships can effectively reduce fuel consumption and CO<sub>2</sub> emissions by using wind energy as the auxiliary driving power. The energy optimization management of the hybrid system can further improve the ship's energy efficiency. To achieve this purpose, it is significant to establish an effective energy...
journal article 2022
document
Zhan, Teng (author), Sun, J. (author), Feng, Tao (author), Zhang, Yulong (author), Zhou, Binru (author), Zhang, Banghong (author), Wang, Junxi (author), Sarro, Pasqualina M (author), Zhang, Kouchi (author)
Recent research focusing on wide-bandgap and two-dimensional materials with a Schottky junction has provided a new concept for ultraviolet photodetectors. However, the working mechanism of the Schottky junction-based detector varies depending on the photosensitive materials used and the device structure. We demonstrated a TiO<sub>2</sub>...
journal article 2022
document
Zhang, Hongzhi (author), He, Yanchen (author), Wang, Chuan (author), Guan, Yanhua (author), Ge, Zhi (author), Sun, Renjuan (author), Ling, Yifeng (author), Šavija, B. (author)
Carbide residue activated blast furnace slag is a relatively new kind of eco-friendly construction materials. This work addresses the design of foamed lightweight concrete as road embankment material using such material. A statistical mixture design approach was adopted to assess the influence of each ingredient as well as the interaction...
journal article 2022
document
Wu, Pingping (author), Wang, Ruihao (author), Lin, Han (author), Zhang, Fanlong (author), Tu, Juan (author), Sun, M. (author)
Depression has become one of the most common mental illnesses in the world. For better prediction and diagnosis, methods of automatic depression recognition based on speech signal are constantly proposed and updated, with a transition from the early traditional methods based on hand-crafted features to the application of architectures of deep...
review 2022
document
Ren, Jie (author), Sun, Hongfang (author), Li, Qun (author), Li, Z. (author), Zhang, Xiaogang (author), Wang, Yanshuai (author), Li, Linfei (author), Xing, Feng (author)
In this research, the effects of natural seawater (SW) on the properties of alkali-activated slag/fly ash (AASF) are studied. AASF prepared with deionized water is set as the reference mixture. The results showed that the use of natural SW resulted in a prolonged setting time and lower heat release, but no obvious impact on the flowability of...
journal article 2022
Searched for: +
(1 - 20 of 27)

Pages