Optical Detection Method for Partial Discharge of Printed Circuit Boards in Electrified Aircraft under Various Pressures and Voltages

Realization of an electrical aircraft demands a low-weight electric distribution and propulsion system. The use of high voltage and power electronics operated at high switching frequencies is essential to achieve this objective. However, printed circuit boards (PCBs) in electrified aircraft are in a harsh working environment, which can make...

Optical Characteristics and Fault Diagnosis of Partial Discharge in C4F7N/CO2 Gas mixture and SF6 Based on Novel Multispectral Microarray Detection

Optical partial discharge (PD) detection is an efficient means of diagnosing the insulation status of power equipment. C4F7N/CO2 gas mixture is a very potential environmentally-friendly SF6 substitute gas, and its PD optical characteristics need to be studied to guide the PD diagnosis of novel C4F7N/CO2 equipment. Therefore, this article...

Forming of magnesium alloy microtubes in the fabrication of biodegradable stents

Magnesium alloys have, in recent years, been recognized as highly promising biodegradable materials, especially for vascular stent applications. Forming of magnesium alloys into high-precision thin-wall tubes has however presented a technological barrier in the fabrication of vascular stents, because of the poor workability of magnesium at room...

Relating tensile properties with flexural properties in SHCC

Strain hardening cementitious composites (SHCCs) have seen increasing field applications in past decade, yet existing quality control test methods for tensile properties are sometime difficult to implement. This paper presents a new simple inverse method for quality control of tensile strain capacity by conducting beam flexural test. It is shown...

Development of engineered cementitious composites with limestone powder and blast furnace slag

Nowadays limestone powder and blast furnace slag (BFS) are widely used in concrete as blended materials in cement. The replacement of Portland cement by limestone powder and BFS can lower the cost and enhance the greenness of concrete, since the production of these two materials needs less energy and causes less CO2 emission than Portland cement...