document

A simulator investigation of helicopter flight control system mode transitions

Reid, L.D. (author), Rajagopal, P. (author), Graf, W.O. (author)

report 1994

document

An evaluation of decelerating IFR approaches utilizing a helicopter flight simulator

Reid, L.D. (author), Advani, S. (author), DeLeeuw, J.H. (author)

report 1991

document

Flight simulation motion-base drive algorithms: part 2. Selecting the system parameters

Reid, L.D. (author), Nahon, M.A. (author)

report 1986

document

Flight simulation motion-base drive algorithms: part 1. Developing and testing equations

Reid, L.D. (author), Nahon, M.A. (author)

report 1985

document

A computer model of driver response

Reid, L.D. (author), Graf, W.O. (author), Stoddard, I.A. (author)

report 1985

document

The simulation of truck motions

Reid, L.D. (author), Nahon, M.A. (author)

report 1985

document

The obstacle acoidance manoeuvre as performed in a tractor/semitrailer truck

Reid, L.D. (author), Graf, W.O. (author), Billing, A.M. (author)

report 1982

document

The validation of linear driver model

Reid, L.D. (author), Graf, W.O. (author), Billing, A.M. (author)

report 1980

document

The analysis of ambient air using atmospheric pressure chemical ionization mass spectrometry

Reid, N.M. (author), French, J.B. (author), Buckley, J.A. (author)

report 1978

document

The real-time detection of trinitrotluente (TNT) in mabient air using the taga system

Reid, N.M. (author), Buckley, J.A. (author), French, J.B. (author)

report 1977

document

The application of techniques for predicting stol aircraft response to wind shear and turbulence during the landing approach

Reid, L.D. (author), Markov, A.B. (author), Graf, W.O. (author)

report 1977

document

Design, construction and calibration of the UTIAS planetary boundary layer simulation tunnel

Reid, L.D. (author), Schuyler, G.D. (author), Teunissen, H.W. (author)

report 1974

document

Stol technology bibliography update

Reid, L.D. (author), de Leeuw, J.H. (author)

report 1971

document

An assessment of stol technology: a strudy prepared for the Canadian Transport Commission Research Division

Reid, L.D. (author), de Leeuw, J.H. (author)

report 1970

document

The measurement of human pilot dynamics in a pursuit-plus-disturbance tracking task

Reid, L.D. (author)

report 1969

document

The design of a facility for the measurement of human pilot dynamics

Reid, L. (author)

report 1965

document

The effects of base bleed on plug nozzles

Reid, J. (author)

This is an experimental comparison of two axi-symmetric, isentropic plug nozzles. In one of these (Model No.1) the afterbody is cylindrical and a secondary flow is bled into the annular base. The other (Model No.2) has a parabolic afterbody with no base or bleed. In both cases the expansion is all-external and the design pressure ratio is 14.

report 1965

document

An experiment on aerodynamic nozzles at M = 2

Reid, J. (author)

In an aerodynamic nozzle a convergent primary nozzle is housed within an afterbody which is surrounded by a shroud. Part of the external flow is captured thereby and compressed by the under-expanded primary jet. At the design point this system is not as efficient as a convergent-divergent nozzle but its off-design performance should be better....

report 1962

document

The effect of a cylindrical shroud on the performance of a stationary convergent nozzle

Reid, J. (author)

One possible method of reducing jet noise at take-off is the use of an ejector in which the propelling nozzle discharges into a shroud and thereby induces a secondary flow. The present report describes an experiment on systems of this type. The primary nozzle was axisymmetric and convergent and the shrouds were cylindrical with faired convergent...

report 1962