On-chip heaters for tension tuning of graphene nanodrums

For the study and application of graphene membranes, it is essential to have means to control their resonance frequency and temperature. Here, we present an on-chip heater platform for local tuning of in-plane tension in graphene mechanical resonators. By Joule heating of a metallic suspension ring we show thermomechanical resonance frequency...

Direct and parametric synchronization of a graphene self-oscillator

Meso Mechanical Analysis of AC Mixture Response

Ongoing research into performance modeling of Asphalt Concrete (AC) mixtures using meso mechanics approaches is being undertaken at Delft University of Technology (TUD). The approach has already been successfully employed for evaluating the long term performance of porous asphalt concrete. The work presented in this paper extends the use for...

Mechanical properties of freely suspended semiconducting graphene-like layers based on MoS2

We fabricate freely suspended nanosheets of molybdenum disulphide (MoS2) which are characterized by quantitative optical microscopy and high-resolution friction force microscopy. We study the elastic deformation of freely suspended nanosheets of MoS2 using an atomic force microscope. The Young’s modulus and the initial pretension of the...

Discrete-time quadrature feedback cooling of a radio-frequency mechanical resonator

We have employed a feedback cooling scheme, which combines high-frequency mixing with digital signal processing. The frequency and damping rate of a 2 MHz micromechanical resonator embedded in a dc SQUID are adjusted with the feedback, and active cooling to a temperature of 14.3 mK is demonstrated. This technique can be applied to GHz resonators...

Tunable Backaction of a DC SQUID on an Integrated Micromechanical Resonator

We have measured the backaction of a dc superconducting quantum interference device (SQUID) position detector on an integrated 1 MHz flexural resonator. The frequency and quality factor of the micromechanical resonator can be tuned with bias current and applied magnetic flux. The backaction is caused by the Lorentz force due to the change in...

Nonlinear Modal Interactions in Clamped-Clamped Mechanical Resonators

A theoretical and experimental investigation is presented on the intermodal coupling between the flexural vibration modes of a single clamped-clamped beam. Nonlinear coupling allows an arbitrary flexural mode to be used as a self-detector for the amplitude of another mode, presenting a method to measure the energy stored in a specific resonance...

Mechanical systems at the nanoscale

This thesis describes experiments that were done with a wide range of nano(electro)mechanical systems (NEMS). These devices are promising candidates to study mechanics in the quantum regime. The experiments range from AFM measurements on few-layer graphene nanodrums, electrical detection of flexural modes of suspended carbon nanotubes both at...

Self-detecting gate-tunable nanotube paddle resonators

We have fabricated suspended metal paddle resonators with carbon nanotubes functioning as self-detecting torsional springs. We observe gate-tunable resonances that either tune to higher or to lower frequencies when increasing the dc voltage on the back gate. We attribute the former modes to flexural vibrations of the paddle resonator, while the...

Nanomechanical properties of few-layer graphene membranes

We have measured the mechanical properties of few-layer graphene and graphite flakes that are suspended over circular holes. The spatial profile of the flake’s spring constant is measured with an atomic force microscope. The bending rigidity of and the tension in the membranes are extracted by fitting a continuum model to the data. For flakes...

Nanoelectromechanics of suspended carbon nanotubes