Searched for: department%3A%22Electrical%255C+Power%255C+Engineering%22
(1 - 20 of 84)

Pages

document
Jassal, A.K. (author)
master thesis 2008
document
Gockel, P.N.M. (author)
In the current society, energy is getting more and more important and one of the most important energy carriers is electricity. TenneT TSO b.v, being the Dutch Transmission System Operator and the administrator of the national transmission grid is responsible not only for the continuity of the electricity supply, but also for the reliability and...
master thesis 2009
document
Wihartady, H. (author)
The short circuit arc is the most dominant fault in the power system that leads to single phase to ground fault. South Sumatera 150 kV system in Indonesia consists of two different string insulator types in the transmission line, with and without arching horn. In this study, some fault situations in that system is reconstructed by using ATP Draw...
master thesis 2009
document
Dakhlan, D.F. (author)
The thesis describes the modeling of the internal faults in three-phase three-winding power transformer related to the differential relay protection behavior due to those faults. This transformer model is based on the mutually coupled [RL] matrix and entirely compatible with ATP/EMTP software. The model uses the real power transformer and the...
master thesis 2009
document
Sihombing, H. (author)
The ambient conditions could influence the breakdown strength of gas insulated substation. It is important to check if this influence will put the GIS into severe condition, especially in the presence of protrusion. A risk assessment is thus important for making decision if the GIS is safe to be operated.
master thesis 2009
document
Nie, L. (author)
Wind energy promises to become an important source of energy in the near future. Penetrating large-scale wind power into power systems presents a lot of challenges to power system operators, generation companies and wind turbine manufactures. In order to design less expensive and more efficient wind turbines, manufacturers have tried a lot of...
master thesis 2009
document
Firmansyah, M. (author)
The concentrated winding is proposed to replace the distributed winding due to the advantages in a manufacturing process. It is easily wounded by a machine in the former and the impregmentation process that can be carried out separately for each individual coil. These advantages can lead to the automation process in winding processes, reduced...
master thesis 2009
document
Ejigu, A.G. (author)
The HCPS group of Electrical Power Engineering department has a Real-Time Digital Simulator (RTDS) for the study and analysis of power system phenomena. RTDS helps to perform real-time simulations that allow the user to interact with the grid model in real time. During this Master thesis work the existing Noord-Holland grid is implemented in...
master thesis 2009
document
Gebrekiros, Y.T. (author)
This thesis deals with characterization of epoxy nanocomposites with different filler types and filler percentages by performing space charge measurements and DC ramp breakdown tests. The space charge measurements were performed at three field levels (10, 15, and 18 kV/mm) using the PEA method. The results were then analyzed. In addition to this...
master thesis 2009
document
Mahes, A. (author)
master thesis 2009
document
Louh, A. (author)
The Dutch electricity grid is considered one of the most reliable in the world. However in the near and far future, significant changes will occur, that will endanger its stability, reliability and safety. Introduction of an embedded wireless sensor network, to determine the state of the power system at any time, in order to cope with these...
master thesis 2009
document
Setyawan, J. (author)
In this study, three artificial defects that represent different type of installation defects are observed by electric field simulation and different energizing and PD detection method. Several measurement issues related to the un-conventional PD measurement are also investigated. The investigation of all these important factors is performed to...
master thesis 2009
document
Zhang, T. (author)
Direct drive generators applied to large wind turbines present some problems, such as very heavy and expensive price. The use of magnetic bearings has a possibility to reduce the weight of the direct drive generator. The control system for such magnetic bearings is considered. In the beginning, the thesis discusses the problems of direct drive...
master thesis 2010
document
Jin, H. (author)
This thesis gives a description of diagnosing life consumption and future life estimation of oil-impregnated paper insulated cable by using dielectric loss value. Dielectric loss values were investigated at different temperatures and different electrical field intensities in the laboratory. Based on laboratory measurements, a program was built;...
master thesis 2010
document
Van Oosterom, J. (author)
A solution is investigated for an auxiliary power supply for the HISPEM project, where a DC/DC converter is needed which is fed by a 540 V DC bus and has an output voltage of 12 V DC. A design using the flyback converter is made, using two different solutions to deal with the relative high input voltage.
master thesis 2010
document
Hong Viet Phuong, N. (author)
Nowadays, the amount of distributed generation (DG) units is increasing rapidly. Most of them are represented by microturbines, combined heat and power (CHP) plants and synchronous generator. At this moment, IEEE 1547 standard states that DG clearing time should be based on the during-fault voltage range. However, DG units will be required to be...
master thesis 2010
document
Diaz Cano, C.M. (author)
master thesis 2010
document
Imoru, O. (author)
The principle of Inductive Power Transfer (IPT) is very old but it is rarely used for transferring power from source to load via a medium. This is because normally the medium restricts the power transfer due to losses or the shielding effects. However, for low energy applications, an acceptable amount of power could be transferred from the...
master thesis 2010
document
Al Fartusi, N. (author)
This project is part of the project “GenPowerBox”; this is a project of the company Mastervolt, realized by Whisper Power. The objective of this project is to develop a compact and noiseless energy management system for use on board of yachts. The “GenPowerBox” system is composed of a battery and a generator set; consisting of a diesel engine...
master thesis 2010
document
Aditya, J. (author)
This thesis is aimed to analyze the effect of test parameters on DRM results from OLTC and its implementation in the condition assessment. Two test parameters were selected to be observed, which are test current and circuit resistance. Their amplitude was varied during the measurements and experiments in the laboratory as well as in the field ...
master thesis 2010
Searched for: department%3A%22Electrical%255C+Power%255C+Engineering%22
(1 - 20 of 84)

Pages