Co-cure joining of epoxy composites with rapidly UV-irradiated PEEK and PPS composites to achieve high structural integrity

Efficient joining of hybrid thermoset/thermoplastic composite joints is critical to produce high performance lightweight structures while keeping the cost low. Herein, a high-power UV-irradiation technique was proposed to rapidly active the surfaces of PEEK and PPS composites for the following co-cure joining with epoxy composites. A single...

Significantly enhanced structural integrity of adhesively bonded PPS and PEEK composite joints by rapidly UV-irradiating the substrates

A high-power UV-irradiation technique was proposed for the surface treatment of PPS and PEEK composites, aiming to achieve good adhesion with epoxy adhesives. The composite substrates were rapidly UV-irradiated for a duration of between 2–30s, and then bonded using an aerospace film adhesive to produce joints. Tensile lap-shear strength and...

The influence of interlayer/epoxy adhesion on the mode-I and mode-II fracture response of carbon fibre/epoxy composites interleaved with thermoplastic veils

The compatibility between the majority of thermoplastic veils (TPVs) and epoxies is typically poor, owing to the inherently low surface energies of thermoplastics. This tends to largely affect the toughening performance of TPVs as interlayer materials of carbon fibre/epoxy composites. The traditional methods for surface activation of...

Using acoustic emission to understand fatigue crack growth within a single load cycle

Current methods for prediction of fatigue crack growth are based on empirical correlations which do not take the crack growth behaviour within a single cycle into account. To improve these prediction methods, more understanding of the physical mechanisms of crack growth is required. In this research the acoustic emission technique was used to...

The effect of temperature on fatigue crack growth in FM94 epoxy adhesive bonds investigated by means of energy dissipation

The effect of temperature on fatigue crack growth in epoxy adhesive bonds was investigated for a range of temperatures from -55 to 80[U+202F]°C. The fatigue crack growth behaviour was characterised using both strain energy release rate (SERR) and by measurements of energy dissipation. It was found that for a given maximum SERR, or a given...

On the physical interpretation of the R-ratio effect and the LEFM parameters used for fatigue crack growth in adhesive bonds

The available models for the prediction of fatigue crack growth in adhesive bonds rely on the similitude principle. In most cases, one of three similitude parameters based on the strain energy release rate (SERR) is used; i.e. G_max, (Δ√G)², or ΔG. In all cases it is usually observed that keeping the similitude parameter...

On the relationship between disbond growth and the release of strain energy

Current prediction methods for growth of disbonds under fatigue loading are generally based on a correlation with either the maximum strain energy release rate (SERR) or the SERR range. This paper highlights some issues with this approach. In particular, it is argued that the maximum SERR or the SERR range alone do not give sufficient...

Towards Understanding Fatigue Disbond Growth via Cyclic Strain Energy

The concept of relating fatigue disbond growth to the strain energy release rate (SERR) is critically examined. It is highlighted that the common practise of using only the maximum SERR or only the SERR range is insufficient to correctly characterize a load cycle. As crack growth requires energy, it is argued that growth should be related to the...