The influence of starter notches on flight simulation fatigue crack growth

An investigation was made of the effect of starter notch geometry on flight simulation fatigue crack growth in three damage tolerant aluminium sheet alloys, 2024-T3, 2091-T84 and 8090-T81. Changing the starter notch geometry resulted in significant differences in initial nonstabilized fatigue crack growth behaviour. However, there was only a...

Damage tolerance property comparisons for 2000 and 8000 series aluminium plate alloys

This report compares the mechanical properties, fracture toughness and fatigue crack growth properties of the damage tolerant/medium strength aluminium plate alloys 2024-T351, 2324-T39, 8090-T651 and 8090-T8171. The main objective, in view of previous work, was to determine whether damage tolerant 8090-T8171 plate can advantageously replace the...

Engineering property comparisons of the aluminium plate alloys 7050-T7365I, 7010-T7365I and 7010-T765I

The Al-Zn-Mg-Cu alloy 7050 produced by Alcoa is a typical plate and forging alloy because of its low quench sensitivity. In order to compare this alloy with the earlier tested plate alloy 7010 an experimental programme was performed involving tensile, fracture toughness, and fatigue testing. In addition stress corrosion crack initiation and...

The influence of different types of anodic layers on the fatigue properties of 202U-T3 and 7056-T6 sheet material

Constant amplitude and flight simulation fatigue tests have been carried out on sulphuric acid, chromic acid and phosphoric acid anodized specimens. A comparison was made with the fatigue behaviour of bare sheet material. Before fatigue testing the fracture strain of the anodic layers was determined.