Despite the lower gravimetric capacity, Li ₄ Ti ₅ O ₁₂ is an important alternative to graphite anodes, owing to its excellent high temperature stability, high rate capability, and negligible volume change. Although surfaces with lithium compositions exceeding Li ₇ Ti ₅ O ₁₂ were observed previously during the first charge-discharge cycles, no stable reversible capacities were achieved during prolonged cycling. Here, structural engineering has been applied to enhance the electrochemical performance of epitaxial Li ₄ Ti ₅ O ₁₂ thin films as compared to polycrystalline samples. Variation in the crystal orientation of the Li ₄ Ti ₅ O ₁₂ thin films led to distinct differences in surface morphology with pyramidal, rooftop, or flat nanostructures for respectively (100), (110), and (111) orientations. High discharge capacities of 280-310 mAh·g ^-1 were achieved due to significant surface contributions in lithium storage. The lithiation mechanism of bulk Li ₄ Ti ₅ O ₁₂ thin films was analyzed by a phase-field model, which indicated the lithiation wave to be moving faster along the grain boundaries before moving inward to the bulk of the grains. The (100)-oriented Li ₄ Ti ₅ O ₁₂ films exhibited the highest capacities, the best rate performance up to 30C, and good cyclability, demonstrating enhanced cycle life and doubling of reversible capacities in contrast to previous polycrystalline studies.

3-D vertically aligned few-layered graphene (FLGs) nanoflakes synthesised using microwave plasma enhanced chemical vapour deposition are melt-impregnated with partially reduced graphene oxide-sulfur (PrGO-S) nanocomposites for use in lithium–sulfur batteries. The aligned structure and the presence of interconnected micro voids/channels in the 3-D FLG/PrGO-S electrodes serves as template not only for the high sulfur loading (up to 80 wt%, areal loading of 1.2 mg cm−2) but also compensates for the volume changes occurring during charge–discharge cycles. The inter-connectivity of the electrode system further facilitates fast electronic and ionic transport pathways. Consequently, the binder-free 3-D FLG/PrGO-S electrodes display a high first-cycle capacity (1320 mA h g−1 at C/20), along with excellent rate capability of ∼830 mA h g−1 and 700 mA h g−1 at 2C and 5C rates, respectively. The residual functional groups of PrGO (–OH, –C–O–C– and –COOH) facilitate fast and reversible capture of Li+ ions while confining the polysulfide shuttles, thus, contributing to excellent cycling capability and retention capacity. The 3D electrodes demonstrate excellent capacity retention of ∼80% (1040 mA h g−1 at C/10) over 350 charge–discharge cycles. Comparatively, the 2-D planar PrGO-S electrodes displayed poor electronic conductivity and can only provide 560 mA h g−1 after 150 cycles, thereby further highlighting the vital role of the electrode morphology in improving the electrochemical performance of Li–S batteries.