In the present study, the nucleation of static recrystallization (SRX) in austenite after hot deformation is experimentally analyzed using a Ni-30 pct Fe model alloy. In agreement with the predictions by current models, nucleation rate exhibits a strong peak, early during SRX. Whereas such an early peak is explained by current models by the saturation of nucleation sites, this condition is far from reached, even after the peak declines. In addition, triple-junction and grain-boundary sites are shown to make a quantitatively similar contribution to nucleation. However, for a given boundary between deformed grains, nucleation predominantly starts at one of the triple junctions. Triple-junction nucleation initiates by strain-induced boundary migration of the nucleus (bulging) along one of the boundaries at the junction. Annealing twin boundaries contribute negligibly to nucleation through their grain-boundary sites. By contrast, their junctions with the boundaries of the parent grains do play a relevant role. The earlier nucleation at the triple junctions is attributed to the higher dislocation density observed around them, and the energy of the boundary consumed by the bulge. Both the maximum and average number of nuclei formed per boundary between deformed grains increase with increasing boundary length.

This study presents the effects of silicon (Si) and manganese (Mn) concentration and of heating rate on the ferrite recrystallization kinetics in seven model alloys with different Si and Mn concentrations, which are of relevance for the development of Advanced High Strength Steels (AHSS). The recrystallization kinetics were studied with in-situ 2D X-ray Diffraction (2D-XRD) and ex-situ microstructure observations using Scanning Electron Microscopy (SEM). The experimentally observed differences in the recrystallization start temperature (Ts), dependent on the Si and Mn concentrations and the heating rate, can be described by combining the non-isothermal JMAK-model with a modified version of Cahn's solute drag model. The modified Cahn model takes into account - in an approximate manner - that the interaction energy of the solute atoms with the grain boundary depends on the Si and Mn concentrations in the boundary and the Wagner interaction parameters. The collective contribution of the Si and Mn atoms to the increase in the Ts with respect to the reference alloy (without Si and with very little Mn) is higher than would be expected from the simple addition of the effects of the Si and Mn concentrations alone. This means that the interaction between Si and Mn atoms leads to an additional increase in Ts, i.e. a coupled solute drag effect. For the later stages of recrystallization, we have studied the change in the number density and the growth rates of the recrystallizing grains using SEM. The observations show non-random nucleation, early impingement of the grains in the normal-direction and non-constant growth rates of recrystallizing grains.