This paper describes a study of the S650 high strength steel material properties including the effect of cold-formed angle. Coupon specimens with different cold-formed angles (90°, 100°, 120°, 140°, 160°and 180°) and different thicknesses (4 mm and 6 mm) were examined. Relationships between cold-formed angle and yield stress as well as tensile stress of the material were determined, based on the tensile coupon test results. Yield and tensile stresses assessed by consid ering the influence of the cold-formed angles were compared with those without considering this influence. Analyses revealed that both yield and tensile stresses decreased with increasing cold-formed angle. Ductile-damage material models available in the finite element analysis software ABAQUS were used to simulate tensile coupon tests. The experimental and numerical results showed good agreements.@en

This paper describes a study of the behaviour of cold-formed high strength steel angles. Thirty-six specimens with different cold-formed angles (90°, 100°, 120°, 140°, 160°, and 170°) and different thicknesses (4 mm and 6 mm) were considered. The initial geometric imperfections of the specimens were determined using the 3D laser scanning method. The magnitudes of these geometric imperfections for torsional and torsional-flexural buckling and flexural buckling analyses were proposed. The commercial finite element analysis (FEA) programme ABAQUS with shell elements S4R was used for finite element analyses. Different material strengths in corner and flat parts along with different proof stresses (0.2%, 0.01%, and 0.006%) were considered in the numerical models. The experimental and FEA results showed good agreement. Influence of cold-formed angle on non-dimensional slenderness and reduction factor curves of the 4 mm thick columns with 90° and 120° cold-formed angles was analysed.@en