Anti-lock braking functions of electric vehicles with individual wheel drive can be effectively realized through the operation of in-wheel or on-board motors in the pure regenerative mode or in the blending mode with conventional electro-hydraulic anti-lock braking system (ABS). The regenerative ABS has an advantage in simultaneous improvement of active safety, energy efficiency, and driving comfort. In scope of this topic, the presented work introduces results of experimental investigations on a pure electric ABS installed on an electric powered sport utility vehicle (SUV) test platform with individual switch reluctance on-board electric motors transferring torque to the each wheel through the single-speed gearbox and half-shaft. The study presents test results of the vehicle braking on inhomogeneous low-friction surface for the case of ABS operation with front electric motors. The performed tests confirm considerable reduction of braking distance and accurate tracking of the reference slip as compared with the vehicle braking without ABS. Hence the pure electric ABS can be considered as an efficient alternative to anti-lock braking systems with friction brakes only.@en

Functions of anti-lock braking for full electric vehicles (EV) with individually controlled wheel drive can be realized through conventional brake system actuating friction brakes and regenerative brake system actuating electric motors. To analyze advantages and limitations of both variants of anti-lock braking systems (ABS), the presented study introduces results of experimental investigations obtained from proving ground tests of all-wheel drive EV. The brake performance is assessed for three different configurations: hydraulic ABS; regenerative ABS only on the front axle; blended hydraulic and regenerative ABS on the front axle and hydraulic ABS on the rear axle. The hydraulic ABS is based on a rule-based controller, and the continuous regenerative ABS uses the gain-scheduled proportional-integral direct slip control with feedforward and feedback control parts. The results of tests on low-friction road surface demonstrated that all the ABS configurations guarantee considerable reduction of the brake distance compared to the vehicle without ABS. In addition, braking manoeuvres with the regenerative ABS are characterized by accurate tracking of the reference wheel slip that results in less oscillatory time profile of the vehicle deceleration and, as consequence, in better driving comfort. The results of the presented experimental investigations can be used in the process of selection of ABS architecture for upcoming generations of full electric vehicles with individual wheel drive.@en