Endovascular thrombectomy procedures are significantly influenced by the mechanical response of thrombi to the multi-axial loading imposed during retrieval. Compression tests are commonly used to determine compressive ex vivo thrombus and clot analogue stiffness. However, there is a shortage of data in tension. This study compares the tensile and compressive response of clot analogues made from the blood of healthy human donors in a range of compositions. Citrated whole blood was collected from six healthy human donors. Contracted and non-contracted fibrin clots, whole blood clots and clots reconstructed with a range of red blood cell (RBC) volumetric concentrations (5–80%) were prepared under static conditions. Both uniaxial tension and unconfined compression tests were performed using custom-built setups. Approximately linear nominal stress–strain profiles were found under tension, while strong strain-stiffening profiles were observed under compression. Low- and high-strain stiffness values were acquired by applying a linear fit to the initial and final 10% of the nominal stress–strain curves. Tensile stiffness values were approximately 15 times higher than low-strain compressive stiffness and 40 times lower than high-strain compressive stiffness values. Tensile stiffness decreased with an increasing RBC volume in the blood mixture. In contrast, high-strain compressive stiffness values increased from 0 to 10%, followed by a decrease from 20 to 80% RBC volumes. Furthermore, inter-donor differences were observed with up to 50% variation in the stiffness of whole blood clot analogues prepared in the same manner between healthy human donors.@en

Background The purpose of this study was to validate a technique for measuring mean calcium density and to determine associations of cardiovascular risk factors with carotid calcium density. Methods and Results We performed a cross-sectional study in a random sample of 100 stroke-free participants from the population-based Rotterdam Study. The mean calcium density of the combined left and right carotid bifurcations was quantified with a threshold of 130 Hounsfield Units (HU) using a novel density technique. To validate the methodology, carotid calcium volumes acquired using the technique in the current study were compared with measurements computed using dedicated clinical software (semiautomatic technique based on a threshold of ≥130 HU). Next, we investigated the associations of participant demographics, total calcium volume, and known cardiovascular risk factors (hypertension, diabetes, hypercholesterolemia, obesity, and smoking status) with the newly derived mean carotid calcium density measurement using linear regression analyses. Calcium volumes obtained with the 2 methods showed a high agreement (intraclass correlation coefficient=0.99, P<0.001), underlining the validity of the density technique. The total calcium volume was statistically significantly associated with the mean calcium density (cardiovascular risk factors adjusted model (B: 0.48 [95% CI, 0.30-0.66], P<0.001). We also found an association between hypercholesterolemia and mean calcium density (0.46 [0.09-0.83], P=0.017). No other significant associations were found between participant demographics or cardiovascular risk factors and mean carotid calcium density. Conclusions We demonstrated the feasibility of a carotid calcium density measurement technique. The data warrant a subsequent longitudinal study to determine the association between carotid calcium density and the risk of cerebrovascular events.@en

Thrombus composition and mechanical properties significantly impact the ease and outcomes of thrombectomy procedures in patients with acute ischemic stroke. A wide variation exists in the composition of thrombi between patients. If a relationship can be determined between the composition of a thrombus and its mechanical behaviour, as well as between the composition of a thrombus and its radiological imaging characteristics, then there is the potential to personalise thrombectomy treatment based on each individual thrombus. This review aims to give an overview of the current literature addressing this issue. Here, we present a scoping review detailing associations between thrombus composition, mechanical behaviour and radiological imaging characteristics. We conducted two searches 1) on the association between thrombus composition and the mechanical behaviour of the tissue and 2) on the association between radiological imaging characteristics and thrombus composition in the acute stroke setting. The review suggests that higher fibrin and lower red blood cell (RBC) content contribute to stiffer thrombi independent of the loading mode. Further, platelet-contracted thrombi are stiffer than non-contracted compositional counterparts. Fibrin content contributes to the elastic portion of viscoelastic behaviour while RBC content contributes to the viscous portion. It is possible to identify fibrin-rich or RBC-rich thrombi with computed tomography and magnetic resonance imaging vessel signs. Standardisation is required to quantify the association between thrombus density on non-contrast computed tomography and the RBC content. The characterisation of the thrombus fibrin network has not been addressed so far in radiological imaging but may be essential for the prediction of device-tissue interactions and distal thrombus embolization. The association between platelet-driven clot contraction and radiological imaging characteristics has not been explicitly investigated. However, evidence suggests that perviousness may be a marker of clot contraction.@en

Thrombus composition and mechanical properties significantly impact the ease and outcomes of thrombectomy procedures in patients with acute ischemic stroke. A wide variation exists in the composition of thrombi between patients. If a relationship can be determined between the composition of a thrombus and its mechanical behaviour, as well as between the composition of a thrombus and its radiological imaging characteristics, then there is the potential to personalise thrombectomy treatment based on each individual thrombus. This review aims to give an overview of the current literature addressing this issue. Here, we present a scoping review detailing associations between thrombus composition, mechanical behaviour and radiological imaging characteristics. We conducted two searches 1) on the association between thrombus composition and the mechanical behaviour of the tissue and 2) on the association between radiological imaging characteristics and thrombus composition in the acute stroke setting. The review suggests that higher fibrin and lower red blood cell (RBC) content contribute to stiffer thrombi independent of the loading mode. Further, platelet-contracted thrombi are stiffer than non-contracted compositional counterparts. Fibrin content contributes to the elastic portion of viscoelastic behaviour while RBC content contributes to the viscous portion. It is possible to identify fibrin-rich or RBC-rich thrombi with computed tomography and magnetic resonance imaging vessel signs. Standardisation is required to quantify the association between thrombus density on non-contrast computed tomography and the RBC content. The characterisation of the thrombus fibrin network has not been addressed so far in radiological imaging but may be essential for the prediction of device-tissue interactions and distal thrombus embolization. The association between platelet-driven clot contraction and radiological imaging characteristics has not been explicitly investigated. However, evidence suggests that perviousness may be a marker of clot contraction.@en

Acute ischemic stroke occurs when a thrombus obstructs a cerebral artery, leading to sub-optimal blood perfusion to brain tissue. A recently developed, preventive treatment is the endovascular stroke treatment (EVT), which is a minimally invasive procedure, involving the use of stent-retrievers and/or aspiration catheters. Despite its increasing use, many critical factors of EVT are not well understood. In this respect, in vitro, and in silico studies have the great potential to help us deepen our understanding of the procedure, perform further device and procedural optimization, and help in clinical training. This review paper provides an overview of the previous in vitro and in silico evaluations of EVT treatments, with a special emphasis on the four main aspects of the adopted experimental and numerical set-ups: vessel, thrombus, device, and procedural settings.@en

Background Clot composition, contraction, and mechanical properties are likely determinants of endovascular thrombectomy success. A pre-interventional estimation of these properties is hypothesized to aid in selecting the most suitable treatment for different types of thrombi. Here we determined the association between the aforementioned properties and computed tomography (CT) characteristics using human blood clot analogues. Methods Clot analogues were prepared from the blood of 4 healthy human donors with 5 red blood cell (RBC) volume suspensions: 0%, 20%, 40%, 60% and 80% RBCs. Contraction was measured as the weight of the contracted clots as a percentage of the original suspension. The clots were imaged using CT with and without contrast to quantify clot density and density increase. Unconfined compression was performed to determine the high strain compressive stiffness. The RBC content was analysed using H&E staining. Results The 5 RBC suspensions formed only two groups of clots, fibrin-rich (0% RBCs) and RBC-rich (>90% RBCs), as determined by histology. The density of the fibrin-rich clots was significantly lower (31-38HU) compared to the RBC-rich clots (72-89HU), and the density increase of the fibrin-rich clots was significantly higher (82-127HU) compared to the RBC-rich clots (3-17HU). The compressive stiffness of the fibrin-rich clots was higher (178–1624 kPa) than the stiffness of the RBC-rich clots (6–526 kPa). Additionally, the degree of clot contraction was higher for the fibrin-rich clots (89–96%) compared to the RBC-rich clots (11–77%). Conclusions CT imaging clearly reflects clot RBC content and seems to be related to the clot contraction and stiffness. CT imaging might be a useful tool in predicting the thrombus characteristics. However, future studies should confirm these findings by analysing clots with intermediate RBC and platelet content. @en