The performance of multiphase flow processes is often determined by the distribution of phases inside the equipment. However, controllers in the field are typically implemented based on flow variables, which are simpler to measure, but indirectly connected to performance (e.g., pressure). Tomography has been used in the study of the distribution of phases of multiphase flows for decades, but only recently, the temporal resolution of the technique was sufficient for real-time reconstructions of the flow. Due to the strong connection between the performance and distribution of phases, it is expected that the introduction of tomography to the real-time control of multiphase flows will lead to substantial improvements in the system performance in relation to the current controllers in the field. This paper uses a gas–liquid inline swirl separator to analyze the possibilities and limitations of tomography-based real-time control of multiphase flow processes. Experiments were performed in the separator using a wire-mesh sensor (WMS) and a high-speed camera to show that multiphase flows have two components in their dynamics: one intrinsic to its nonlinear physics, occurring independent of external process disturbances, and one due to process disturbances (e.g., changes in the flow rates of the installation). Moreover, it is shown that the intrinsic dynamics propagate from upstream to inside the separator and can be used in predictive and feedforward control strategies. In addition to the WMS experiments, a proportional–integral feedback controller based on electrical resistance tomography (ERT) was implemented in the separator, with successful results in relation to the control of the distribution of phases and impact on the performance of the process: the capture of gas was increased from 76% to 93% of the total gas with the tomography-based controller. The results obtained with the inline swirl separator are extended in the perspective of the tomography-based control of quasi-1D multiphase flows.@en

Today's mechanical fluid separators in industry are mostly operated without any control to maintain efficient separation for varying inlet conditions. Controlling inline fluid separators, on the other hand, is challenging since the process is very fast and measurements in the multiphase stream are difficult as conventional sensors typically fail here. With recent improvement of process tomography sensors and increased processing power of smart computers, such sensors can now be potentially used in inline fluid separation. Concepts for tomography-controlled inline fluid separation were developed, comprising electrical tomography and wire-mesh sensors, fast and massive data processing and appropriate process control strategy. Solutions and ideas presented in this paper base on process models derived from theoretical investigation, numerical simulations and analysis of experimental data.@en

This text structures the application of Wire-Mesh sensors and Electrical Resistance Tomography in the control of an Inline Swirl Separator. It introduces a mechanistic model of the two-phase flow inside the device, which is linearized around an ideal perfect operation, and implemented in a Model Predictive Controller. The whole text is structured aiming at a future real application of the controller, briefly introducing the setup that is going to be used, the sensors and their working principles. The results obtained show a stable controller, able to regulate the process relatively fast in relation to the time resolution of the sensors. The positive response of the approach stimulates further improvements in the model developed, and the implementation of more sophisticated techniques to handle the non-linearities of the process.@en