In this paper, a methodology to capture the model-based haptic feedback control reference for closed-loop steering systems is demonstrated. The parameterisation is based on the measurements of open-loop driving manoeuvres for the inertia-spring-damper-friction reference model. The steady-state and transient manoeuvres are used to identify the model parameters. The reference model is limited to the haptic feedback of driver excitation in the linear vehicle handling range and intended to be used in closed-loop steering control strategies. The model parameters have an intuitive interpretation that allows to be used in both admittance and impedance control setting. The feasibility of the proposed model is demonstrated in a validated simulation environment for electric power assisted steering and on a real hardware for the steer-by-wire force-feedback case.@en

This paper illustrates a comparison of different haptic feedback control strategies; primarily focusing on open and closed-loop methods for a Force-Feedback Steer-by-Wire system. Due to shortcomings caused by the feedback motor impedance in the open loop architecture, the tracking performance is deteriorated. Consequently it is shown that the closed-loop solutions provide an improved response within the desired steering excitation range. The closed-loop possibilities, torque and position control, are designed and objectively compared in terms of performance and stability. The controller objectives are inertia compensation and reference tracking. For a given reference, the stability constraint between the controller gains responsible for the two objectives is contrasting in both the methods. Higher bandwidth is achieved for torque controller, whereas the driver arm inertia limits the position control performance. The linear system analysis is supported by the experimental results.@en