The electrification of chemical processes and CO₂ utilization are key approaches to improving efficiency and reducing CO₂ emissions in the process industry. The development of electrolyzers has gathered momentum, enabling the potential introduction of renewable electrons into the manufacture of CO₂-based chemicals. While the performance of electrolyzers is subject to improvements driven by the experimental community, the generation of waste heat is unavoidable due to electrical resistances and process inefficiencies within the electrochemical cells. Nonetheless, reusing this waste heat has yet to be investigated for CO₂ electrolyzers. This novel work shows the potential for upgrading the electrolyzer waste heat by means of a heat pump, enabling its utilization in the separation processes downstream of the carbon dioxide electrolyzer. The product chosen is formic acid (60 kt/y), and for our system, the waste heat represents approximately 60 % of the power input to the electrochemical cells, and it can be upgraded from 50 °C to 120 °C to drive the azeotropic distillation of formic acid and water. This integration results in the electrification of 76 % of the separation energy duty, yielding a decrease in CO₂ emissions of 29–84 % compared to the conventional production, depending on the source of electricity. The results demonstrate that the use of traditional heating media in thermal separation processes can be offset and substituted with (renewable) electrical energy, allowing for an increased overall system efficiency. This approach can be readily extended to different productions based on carbon dioxide electroreduction, for example for methanol and ethanol manufacture. This eco-efficient process design leads to a deeper penetration of renewable energy into chemical manufacturing, as both reaction and separation are driven by electricity. ... Read more

Despite the huge efforts devoted to the development of the electrochemical reduction of CO2 (ECO2R) in the past decade, still many challenges are present, hindering further approaches to industrial applications. This paper gives a perspective on these challenges from a Process Systems Engineering (PSE) standpoint, while at the same time highlighting the opportunities for advancements in the field in the European context. The challenges are connected with: the coupling of these processes with renewable electricity generation; the feedstock (in particular CO2); the processes itself; and the different products that can be obtained. PSE can determine the optimal interactions among the components of such systems, allowing educated decision making in designing the best process configurations under uncertainty and constrains. The opportunities, on the other hand, stem from a stronger collaboration between the PSE and the experimental communities, from the possibility of integrating ECO2R into existing industrial productions and from process-wide optimisation studies, encompassing the whole production cycle of the chemicals to exploit possible synergies. ... Read more

As the urgency of reducing greenhouse gas emissions increases, the chemical industry is moving towards more sustainable applications, such as substituting fossil feedstock with renewable ones. The development and implementation of novel technologies will entail momentous, system-wide changes to allow for the production of chemicals and fuels. This work aims at providing an overview of the energy requirements for the production of several chemicals by means of electrochemical reduction of CO2 (ECO2R), in order to aid the decision-making process to select the products on which further research and development efforts should focus.

The results demonstrate that the production of C1 oxygenated molecules, such as carbon monoxide and methanol, via ECO2R would have significantly lower requirements in terms of renewable energy generation when compared to fully reduced hydrocarbons (methane, ethylene) and ethanol. This would lead to a less demanding implementation of electrochemical CO2 utilisation technologies, allowing for a more streamlined deployment of ECO2R within existing supply chains. ... Read more