Frequency-sweeping interferometry (FSI) is an advanced coherent measurement technique capable of simultaneous high-precision measurement of dynamic target absolute distance and velocity. This study reveals that the dynamic target modulates the beat signal in FSI, causing the phase jump phenomenon in the beat signal and subsequent measurement failures. We theoretically derive and experimentally validate the conditions for phase jumps. Additionally, we propose using time-frequency analysis methods to detect phase jump instants and reconstruct the instantaneous frequency trajectory of the beat signal modulated by phase jumps. Experimental results show that even with phase jumps, we achieved a dynamic velocity measurement of −135.40 mm/s on a 0.5 m baseline, surpassing the theoretical limit of −4.40 mm/s under this baseline, while maintaining effective measurement capability on an extended 10 m baseline. The discovery and resolution of phase jumps are expected to overcome velocity limitation in FSI, significantly expanding its velocity measurement range.

The use of CSA cement in practice has been hindered by its unstable performance and short shelf-life caused by the prehydration of CSA clinker. In this study, the effect of ambient humidity on the prehydration rate and process of CSA clinker was investigated. The prehydration degree, ageing progress, and the dynamic change of mineral composition of CSA clinker exposed to five different relative humidities (ranging from 23% to 98%) for up to 180 days were studied. Experiments revealed that the ambient humidity of 60% RH can be considered a threshold value for storage of CSA clinker. Exposure of CSA clinker to RH higher than 60% will not only result in a significant decrease of hydraulic reactivity, but also in agglomeration of the clinker. Although the exposure of CSA clinker to RH lower than 60% has little effect on the hydraulic reactivity, the main hydration peak was found to be slightly delayed with the increase of RH.