As the world population is increasing and cities grow faster than before, food scarcity becomes a bigger issue. To depend less on import and decrease CO2 footprint, food should be produced nearby its consumers. A good solution for food production is a greenhouse which provides a steady high yield throughout the year. Some of the world's fastest growing cities are in Subtropical climates. Subtropical climates are characterized by high temperatures, abundance of sun and high humidity. Due to the high temperatures, cooling in greenhouses in subtropical climates is necessary, but evaporative cooling is not sufficient due to the high humidity. Outside air can be dehumidified by a liquid desiccant to cool the air further with an extra evaporative cooling step. After dehumidifying the air, the absorbed moisture from the air in the desiccant must be removed from the desiccant solution for re-use. This requires a lot of energy, which makes this cooling technique for greenhouses in subtropical climates not economically feasible. The proposed solution is to remove moisture from the desiccant by making use of the hot air that can be collected in the top of the greenhouse. The potential of this solution is assessed in this study. To predict the transfer of mass and heat between air and a calcium chloride solution as desiccant, a mathematical model of the process of mass and heat transfer over a structured cardboard pad is made. An experiment is conducted to validate the mass and heat transfer coefficients of the model. The model is used to evaluate the workings of the proposed system of regeneration. Results show that dehumidification can significantly lower the inlet temperature of the air in the greenhouse, provided that the inlet temperature of the desiccant is low. Regeneration of the desiccant solution with hot air is also possible, provided that the air in the greenhouse is significantly heated by the sun and pre-heating of the desiccant before regeneration is beneficial. The direct coupling of these two systems is not sufficient due to the big difference in temperature of the desiccant that is required at the inlet of the dehumidifier and regenerator. In future work attention should be paid to this temperature difference which is currently limiting the performance of the system. Then it's possible for the concentration of the desiccant to be brought back to the starting conditions for the dehumidifier.