The electrochemical CO₂ reduction reaction (CO₂RR) in a membrane electrode assembly (MEA) efficiently turns CO₂ into a feedstock. However, unfavorable steady-state concentrations of ions in the cathode compartment result in salt formation if unaddressed, which restricts the access of CO₂ and causes cell failure. Here, we systematically show the relationship between salt accumulation and four system parameters including cation species, anolyte concentration, membrane thickness, and operating temperature. To compare each metric, we quantified the cation accumulation rate at predefined operating times. Notably, we show that operating at temperatures above 50 °C with properly humidified CO₂ stream fully avoids salt formation. We further show that combining separate operating conditions is also highly effective, showing operation for >144 h with no measurable salt deposition at 200 mA/cm². Collectively, our work systematically demonstrates that salt formation is a prevalent yet surmountable CO₂RR challenge that can be overcome by elevated cell temperatures or switching to more soluble alkali cations. ... Read more

CO2 conversion is an important part of the transition towards clean fuels and chemicals. However, low solubility of CO2 in water and its slow diffusion cause mass transfer limitations in aqueous electrochemical CO2 reduction. This significantly limits the partial current densities towards any desired CO2-reduction product. We propose using flowable suspension electrodes to spread the current over a larger volume and alleviate mass transfer limitations, which could allow high partial current densities for CO2 conversion even in aqueous environments. To identify the requirements for a well-performing suspension electrode, we use a transmission line model to simulate the local electric and ionic current distributions throughout a channel and show that the electrocatalysis is best distributed over the catholyte volume when the electric, ionic and charge transfer resistances are balanced. In addition, we used electrochemical impedance spectroscopy to measure the different resistance contributions and correlated the results with rheology measurements to show that particle size and shape impact the ever-present trade-off between conductivity and flowability. We combine the modelling and experimental results to evaluate which carbon type is most suitable for use in a suspension electrode for CO2 reduction, and predict a good reaction distribution throughout activated carbon and carbon black suspensions. Finally, we tested several suspension electrodes in a CO2 electrolyzer. Even though mass transport limitations should be reduced, the CO partial current densities are capped at 2.8 mA cm−2, which may be due to engineering limitations. We conclude that using suspension electrodes is challenging for sensitive reactions like CO2 reduction, and may be more suitable for use in other electrochemical conversion reactions suffering from mass transfer limitations that are less affected by competing reactions and contaminations. ... Read more