The displacement of a loudspeaker cone is not linearly proportional to the voltage/current at its input provided. This is due to electrical and mechanical limitations. The distortion is more noticeable at lower frequencies. This report is one of two reports, that will explain how to minimize this distortion. The motion of the loudspeaker cone will be measured and compared with the input voltage. This way the error in the output can be found. Finally, a system will adjust the current through the voice coil to decrease this error. An accelerometer is used as a sensor and the ADAU1777 is used to compensate for the error in output displacement. Finally, a voltage to current converter is used to convert and amplify the output voltage from the ADAU1777 into a current signal to drive the loudspeaker. This report focuses on the voltage to current amplifier. To begin the design, a problem definition and program of requirements will be given. Usually, loudspeakers are voltage driven. This report begins by first explaining why a current-driven loudspeaker delivers less distortion. Then an attempt is made to build a single operational amplifier (opamp) design that meets the requirements for a real load. For the single opamp design, a simple version of the operational transconductance amplifier (OTA) will be compared against a Howland model based on noise performance and circuit analysis, where it will be shown that the simple OTA has a larger signal to noise ratio and does not need to meet any additional criteria to maintain a high output impedance. However, the simple OTA still does not meet the Signal to Noise (SNR) . The simple OTA also did not meet the maximum Total Harmonic Distortion (THD) at 800 Hz. Then, a two opamp design will be constructed using a composite configuration to increase the SNR and decrease the THD. This design does meet the requirements given, at least for a purely resistive load. Then an electrical model of a loudspeaker, which has a complex impedance, will replace the resistive load. Now the composite design for the resistive load needs to be adjusted for the inductive characteristic of a loudspeaker at higher frequencies. The resulting design has a THD of 0.000427\%, a PM of 51$\degree$ and a SNR is 100.92 dB. All results will be given as simulations, because the current pandemic (COVID-19) does not make it possible to physically construct and measure this model. Micro-Cap 12 is used for circuit simulations and Slicap for circuit noise analysis.