The increasing demand for electricity and the need to decelerate the use of fossil fuels to prevent a dramatic climate change have urged the need for new sources of energy. Thus, electrical sustainable energy is an ever growing field. Investigations into performance improvements and extraction of maximum benefits from Renewable Energy Sources (RES) is the need of the hour. In particular, wind power contributes to a significant share of renewable electricity generation and has seen great leaps in terms of implemented technologies. The advancements in wind turbine technology have introduced converter based generation, thereby affecting the electrical grid's inertia and short circuit current contributions. These short circuit contributions have been of particular interest for protection engineers in the development of protection systems worldwide. TenneT, which is the TSO of the Netherlands, faces the challenge regarding the protection scheme implementation for their upcoming offshore wind farm connections involving Type 4 Wind Turbines (WT). The lower magnitudes of current flow, post fault and the presence of balanced currents irrespective of the type of fault are some of the major challenges. The system starting from the busbar (where WTs are connected) is owned by the system operator and the WT along with the cable connecting to the busbar, or the Point of Common Coupling (PCC) is an asset of the Wind Park Operator (WPO). Non-technical issues such as the ownership of components at the point of common coupling between the wind park operators and the system operators together along with the technical challenges described earlier necessitates the development of a standard protection scheme that provides satisfactory performance. Implementation of end-to-end connection protection system for the individual component protection is also challenging considering the challenges associated with the ownership of the assets. Therefore , it is necessary to analyse the performance of conventional protection systems (single unit operation). The performance of definite time overcurrent, directional overcurrent, under voltage and distance protection have been studied for faults on PCC and the infeed WPO strings. The study aims at finding the right choice of primary and back up protections that are independent of the type of short circuit currents available by the generation technologies. In addition, the research aims to develop a new busbar protection scheme that can detect and identify the fault location with the challenges explained before. Following the undesirable behaviour observed with overcurrent and directional overcurrent protection system the author then proposes two new schemes using conventional protection systems. The considerations regarding successful operation of under voltage protection and distance protection are further addressed. Finally, a new scheme involving fault generated travelling waves to detect fault on the network is extensively tested. All the protection systems are then compared to describe their merits and demerits to make a decision about the primary and backup protection implemented.

Wind farms are currently built in the North Sea in the Netherlands. The grid connecting the off-shore wind farm to the main-land distribution grid must be protected against short-circuits and other electrical disturbances. In this project is studied if electrical protection of a grid is suitable for grids connecting renewable energy sources to the transmission grid. The research question is as follows: Does the distance protection function of a protection relay respond correctly to all faults in a wind farm electrical grid? The research question is tried to be answered through simulations and tests. Faults are simulated, and a part of the grid is tested in a real protection relay. The results of these tests show that the protection relay does not always react as expected. Results are analyzed to explain these unexpected results. A situation with a three-phase fault and a situation with a two-phase to ground fault caught the attention. These two unexpected results are analyzed with calculations to explain the behavior and find the cause. The calculations give more insight, but no single solution has been found. Recommendations are given to reduce the change of undesired behavior of the protection relay.