Heat pipes are typically used in the semiconductor industry. This means that the scale of these heat pipes is typically in the order of centimeters. Zijm suggests that heat pipes could be used for geothermal applications, but literature is lacking. To further investigate the geothermal application of heat pipes, a large scale heat pipe is built. This thesis gives an insight in the typical design challenges that one faces when constructing a heat pipe of this scale. The heat pipe that is constructed can support a heat flow of 10 kW. The heat pipe is constructed from mainly 54 millimeter copper and glass pipes. The evaporator section is 1.5 meters long and facilitates controlled electric heating. Then follows a 4 meter long adiabatic section. The condenser section is 2.5 meters long. The total length of the heat pipe is 9 meters. The individual sections are held together by EPDM connectors. The dimensions of the heat pipe are compared to the operational limits posed by the Engineering Sciences Data Unit. Then the thermal resistances of the heat pipe sections are calculated and afterwards validated. The interfacial thermal resistance between the electric heaters and evaporator wall was reduced by applying thermal conduction paste to the band heaters. It was found that at coolant flows of 1000 l/h and higher, the vapour temperature in the heat pipe drops significantly. The drop in temperature facilitates a higher heat flow through the heat pipe. Also, the resistance across the evaporator and the condenser section gets smaller for higher coolant flows. The results found are supported by theory and formulae from the Engineering Sciences Data Unit.

Heatpipes are promising devices for geothermal energy extraction owing to their
effectiveness to transport heat. The goal of this research is to validate an analytical heatpipe model with experiments and to investigate the difficulties in designing and constructing geothermal heatpipes. There is a lack of literature and research concerning the operation, performance limits and construction of heatpipes suitable for geothermal heat extraction. A prototype heatpipe is designed based on specifications for geothermal energy extraction and constructed in a laboratory set-up with sensors and data acquisition. The prototype setup collects experimental data and is used to evaluate important parameters, requirements and practical design difficulties. This research shows the difficulties in designing a geothermal heatpipe taking into account fluid choice and physical limitations as well as complications in constructing a properly sealed heatpipe under the influence of repeated heating and cooling. Furthermore it shows the limitations of the analytical model by comparing the model predictions with experimental data.