A shared PV system for transportation and residential loads to reduce curtailment and the need for storage systems

This paper proposes a shared multi-stakeholder PV system for traction substations and nearby residential loads to reduce the need for storage, AC grid exchange, and curtailment. The residential stakeholders offer both the base electrical load and the solar panels installation space needed by the traction stakeholder, who brings the peak load...

Opportunity Charging of Electric Buses Directly from a DC Metro Catenary and Without Storage

A typical approach to harvesting the excess braking energy of a railway car has been to use a storage system. However, research momentum has been growing in the direction of integrating smart loads like EV chargers into traction networks, and this can offer a more efficient and economical solution to the harvesting of braking energy. This paper...

Increasing the Braking Energy Recuperation in Electric Transportation Grids Without Storage

When the braking energy in electric transportation grids is not met by another vehicle's demand, it is either harvested by storage systems or wasted in braking resistors. This paper looks at three methods for increasing the amount of harvested braking energy without the use of expensive storage systems: decreasing the substation voltage,...

Methods for increasing the potential of integration of EV chargers into the DC catenary of electric transport grids: A trolleygrid case study

The traction substations of urban electric transport grids are oversized and underutilized in terms of their capacity. While their over-sizing is an unfortunate waste, their under-utilization creates the major hurdle for the integration of renewables into these grids due to the lack of a base load. Therefore, integrating smart grid loads such...

A simple method for sizing and estimating the performance of PV systems in trolleybus grids

Solar PV systems have so far been the source of choice for the sustainable supply of urban electric transport networks—like trams and trolleybus grids. However, no consensus exists yet on the placement or sizing of PV systems at the traction substations, and no method is available for easy estimation of the PV system utilization performance....

An Adaptive Battery Charging Method for the Electrification of Diesel or CNG Buses as In-Motion-Charging Trolleybuses

The decarbonization of urban bus fleets can be made by their electrification as in-motion-charging (IMC) buses which can run as trolleybuses or in battery mode. The benefit is that IMC buses can use the existing trolleygrid infrastructure where their route overlaps with it to charge the battery and operate in battery mode outside of it....

A Complete DC Trolleybus Grid Model With Bilateral Connections, Feeder Cables, and Bus Auxiliaries

This paper offers a complete and verified model of DC trolleybus grids and examines the effect of the common modelling assumptions made in literature by using simulations, as well as bus and substation measurements from the grid of Arnhem, the Netherlands. An equivalent model for the overhead line impedance is offered taking into account the...

A Review of the Key Technical and Non-Technical Challenges for Sustainable Transportation Electrification: A Case for Urban Catenary Buses

The transport sector has been increasing rather than decreasing its CO2 emissions, and its sustainable electrification faces a number of technical and non-technical challenges. This paper investigates these challenges, namely those of the grid load demand modelling, renewables integration, the present infrastructure limitations, and the...

Toward a Better Estimation of the Charging Corridor Length of In-Motion-Charging Trolleybuses

In-Motion-Charging (IMC) buses are destined to become a key player in sustainable urban transport as they combine the advantages of both trolleybuses (overhead supply mode) and e-buses (on-board battery mode). Defining the route ratio of these two modes of operation is a critical task in order to ensure that the IMC battery can complete a...

Placement and sizing of solar PV and Wind systems in trolleybus grids

Reducing the environmental impact of transportation requires the successful integration of renewable energy sources into the electrical transportation networks. However, the mismatch between renewable generation and the intermittent bus schedules causes temporary absence of loads and creates considerable excess energy, potentially rendering...

Increasing the Integration Potential of EV Chargers in DC Trolleygrids: A Bilateral Substation-Voltage Tuning Approach

Light rail networks such as trolleybus grids have the potential to become multi-functional smart grids by using the excess capacity of the grid to implement PV systems, EV chargers, and storage. This paper offers a solution to increasing the potential for integration of EV chargers in the trolleygrid, without additional infrastructure costs,...