Searched for: subject%3A%22temperature%255C+sensor%22
(21 - 40 of 102)

Pages

document
Gürleyük, C. (author), Pan, S. (author), Makinwa, K.A.A. (author)
This article presents a 16-MHz RC frequency reference implemented in a standard 180-nm CMOS process. It consists of a frequency-locked loop (FLL) in which the output frequency of a digitally controlled oscillator (DCO) is locked to the frequency-phase characteristic of a Wien bridge RC filter. Since it is made from on-chip resistors and...
journal article 2022
document
Heymans, Sophie V. (author), Collado Lara, G. (author), Rovituso, M. (author), Vos, H.J. (author), D'hooge, Jan (author), de Jong, N. (author), Van Den Abeele, Koen (author)
Superheated nanodroplet (ND) vaporization by proton radiation was recently demonstrated, opening the door to ultrasound-based in vivo proton range verification. However, at body temperature and physiological pressures, perfluorobutane nanodroplets (PFB-NDs), which offer a good compromise between stability and radiation sensitivity, are not...
journal article 2022
document
Someya, T. (author), Van Hoek, Vincent (author), Angevare, J. (author), Pan, S. (author), Makinwa, K.A.A. (author)
This letter describes an NPN-based temperature sensor that achieves a 1-point trimmed inaccuracy of ±0.15 °C (3σ) from -15 to 85 °C while dissipating only 210 nW. It uses a dual-mode frontend to roughly halve the power consumption of conventional frontends. First, two NPNs are used to generate a well-defined PTAT bias current, then this...
journal article 2022
document
Shao, Pengfei (author), Ma, C. (author), Han, Daoyang (author), Liu, Kun (author), Li, Mingliang (author), Liang, Yi (author), Yao, Meng (author), Wang, Hailong (author), Zhang, Rui (author), Shao, Gang (author)
Temperature sensors that can operate in high-temperature and harsh environments are highly desired. However, this is a great challenge for sensing materials to operate under extreme working conditions because of oxidation and/or corrosion at high temperature. In this study, polymer-derived SiAlCN ceramics were prepared as sensing materials to...
journal article 2022
document
Toth, Nandor (author)
This thesis presents an energy-efficient high-accuracy temperature sensor that combines a BJT front-end with a continuous-time readout circuit. Its front-end is based on PNP transistors, which, compared to NPNs, are more widely available in CMOS processes and less sensitive to stress. In this design, proportional-to-absolute-temperature (PTAT)...
master thesis 2021
document
Abarca Prouza, A.N. (author)
This thesis describes the integration of temperature sensors into a CMOS image sensor (CIS). The temperature sensors provide the in-situ temperature of the pixels as well as the thermal distribution of the pixel array. The temperature and the thermal distribution are intended to be used to compensate for dark current affecting the CIS. Two...
doctoral thesis 2021
document
Pan, S. (author)
This thesis describes the design and implementation of integrated temperature sensors based on the temperature dependency of CMOS resistors.
doctoral thesis 2021
document
Schenato, Luca (author), Aguilar Lopez, J.P. (author), Galtarossa, Andrea (author), Pasuto, Alessandro (author), Bogaard, T.A. (author), Palmieri, Luca (author)
This paper describes the implementation of an FBG sensor to measure water levels in a dike. The sensor is based on a 3D-printed mechanical transducer through which the external pressure is converted into longitudinal strain exerted on the fiber. An additional FBG integrated within the sensor measures temperature and is used to compensate for...
journal article 2021
document
Martins Da Ponte, R. (author), Gaio, N. (author), van Zeijl, H.W. (author), Vollebregt, S. (author), Dijkstra, Paul (author), Dekker, R. (author), Serdijn, W.A. (author), Giagka, Vasiliki (author)
One of the many applications of organ-on-a-chip (OOC) technology is the study of biological processes in human induced pluripotent stem cells (iPSCs) during pharmacological drug screening. It is of paramount importance to construct OOCs equipped with highly compact in situ sensors that can accurately monitor, in real time, the extracellular...
journal article 2021
document
Romijn, J. (author), Middelburg, L.M. (author), Vollebregt, S. (author), el Mansouri, B. (author), van Zeijl, H.W. (author), May, Alexander (author), Erlbacher, Tobias (author), Zhang, Kouchi (author), Sarro, Pasqualina M (author)
Accurately sensing the temperature in silicon carbide (power) devices is of great importance to their reliable operation. Here, temperature sensors by resistive and CMOS structures are fabricated and characterized in an open silicon carbide CMOS technology. Over a range of 25-200°C, doped design layers have negative temperature coefficients of...
conference paper 2021
document
Tang, Z. (author), Fang, Yun (author), Yu, Xiao Peng (author), Tan, Nick Nianxiong (author), Shi, Zheng (author), Harpe, Pieter (author)
This work presents an energy-efficient diode-based CMOS temperature sensor. It is based on the capacitively biased diode (CBD) working principle and can operate with a 1-V supply voltage. Instead of using a separate CBD front-end and ADC, a new architecture is proposed in which the CBD front-end is directly embedded into the 1st stage of a 1...
journal article 2021
document
Huang, Zhenyan (author), Tang, Z. (author), Yu, Xiao Peng (author), Shi, Zheng (author), Lin, Ling (author), Tan, Nick Nianxiong (author)
This brief presents a 0.65% relative inaccuracy CMOS temperature sensor with a duty-cycle-modulated (DCM) output. It uses a BJT-based front-end to generate a proportional to absolute temperature voltage (V_{PTAT}) and a complementary to absolute temperature voltage (V_{CTAT}), which are then modulated to a digital-friendly duty-cycle output....
journal article 2021
document
Pan, S. (author), Angevare, J. (author), Makinwa, K.A.A. (author)
This article describes a hybrid temperature sensor in which an accurate, but energy-inefficient, thermal diffusivity (TD) sensor is used to calibrate an inaccurate, but efficient, resistor-based sensor. The latter is based on silicided polysilicon resistors embedded in a Wien-bridge (WB) filter, while the former is based on an electrothermal...
journal article 2021
document
Abarca Prouza, A.N. (author), Theuwissen, A.J.P.A.M. (author)
This article presents in-pixel (of a CMOS image sensor (CIS) temperature sensors with improved accuracy in the spatial and the temporal domain. The goal of the temperature sensors is to be used to compensate for dark (current) fixed pattern noise (FPN) during the exposure of the CIS. The temperature sensors are based on substrate parasitic...
journal article 2020
document
Huiskes, Martijn (author), Miao, Michael (author)
Fruit-frost during spring is one of the main causes of damage to the harvest of fruit in orchards. Various systems using different methods of preventing spring-frost are available on the market. To determine when these systems should be activated, the temperature in the orchard needs to be determined. In this project, a self-sustaining...
bachelor thesis 2020
document
Sonmez, U. (author)
Today’s systems-on-chip (SOCs) and microprocessors are complex systems that require multiple temperature sensors to monitor temperature variations in multiple spots on a single silicon die. For such thermal management applications, specialized compact and fast temperature sensors are required. This is necessary because executing an intensive...
doctoral thesis 2020
document
Xie, S. (author), Theuwissen, A.J.P.A.M. (author)
This paper presents a CMOS image sensor (CIS) with a zoom ADC, to quantize in-pixel temperature sensors, as well as for faster readout speed of the image pixels while maintaining low quantization noise. The proposed 15 bit zoom ADC has a 4 bit Unit Capacitor Array (UCA) SAR and a 13 bit incremental 2<sup>nd</sup>-order delta-sigma ADC (DSADC)...
journal article 2020
document
Yousefzadeh, B. (author), Makinwa, K.A.A. (author)
This article presents a BJT-based temperature-to-digital-converter (TDC) that achieves ±0.25 °C 3 sigma -inaccuracy from -40 °C to +180 °C after a heater-assisted voltage calibration (HA-VCAL). Its switched-capacitor (SC) ADC employs two sampling capacitors and, thus, the minimum number of critical sampling switches, which minimizes the...
journal article 2020
document
't Hart, P.A. (author), Babaie, M. (author), Charbon-Iwasaki-Charbon, E. (author), Vladimirescu, A. (author), Sebastiano, F. (author)
This paper presents a device matching study of a commercial 40-nm bulk CMOS technology operated at cryogenic temperatures. Transistor pairs and linear arrays, optimized for device matching, were characterized over the temperature range from 300 K down to 4.2 K. The device parameters relevant for mismatch, i.e., the threshold voltage and the...
journal article 2020
document
Deutz, D.B. (author), van der Zwaag, S. (author), Groen, W.A. (author)
As demand rises for flexible electronics, traditionally prepared sintered ceramic sensors must be transformed into fully new sensor materials that can bend and flex in use and integration. Negative temperature coefficient of resistance (NTC) ceramic thermistors are preferred temperature sensors for their high accuracy and excellent stability,...
journal article 2020
Searched for: subject%3A%22temperature%255C+sensor%22
(21 - 40 of 102)

Pages