Recent studies on distributed electric propulsion systems suggest phase synchronization between rotors as a noise reduction strategy. However, the aerodynamic interactions between propellers' near fields and their influence on far-field tonal noise remain poorly understood, partly due to experimental limitations in microphone placement. This paper addresses this gap through lattice Boltzmann very large eddy simulations of three adjacent, co-rotating rotors, spaced radially at 2% of their diameter, to investigate how relative phase angle affects tonal noise directivity. Results reveal that proximity-induced aerodynamic interactions generate dominant tonal noise in most spatial directions, driven by two mechanisms: time-averaged inflow distortion from nearby propellers and impulsive local effects at blade tips, with the latter influenced by phase angle. While the directivity pattern of the blade-passing frequency harmonic tone remains consistent across phase angles, comparing cases with zero relative phase (blades aligned) and opposite-phase conditions shows sound pressure level shifts of up to 4.5 dB along the primary noise axis, namely, along the inflow direction. Conversely, acoustic interference significantly alters noise directivity, especially in opposite-phase conditions where sound is nearly canceled in specific directions. These findings highlight rotor synchronization as a promising strategy for reducing noise emissions toward sensitive areas.

This work examines the control of cross-flow instabilities (CFIs) and laminar–turbulent transition on a swept wing, through the plasma-based base flow modification (BFM) technique. The effect of experimentally derived plasma body forces on the steady boundary layer base flow is explored through numerical simulations. Linear stability theory is subsequently used to predict the net BFM effect on CFIs. Based on these preliminary predictions, experiments are conducted in a low-turbulence wind tunnel where a spanwise-invariant plasma actuator is installed near the wing leading edge and operated at constant input voltage and frequency. Various flow parameters governing the plasma-based BFM technique are investigated, namely the Reynolds number, angle of attack and wavelength of excited stationary CFI modes. Stationary and travelling CFIs are quantified by planar particle image velocimetry while the transition topology and location are recorded by infrared thermography. The results confirm the stabilising effect of BFM on the swept-wing boundary layer. However, the plasma-based BFM is found to render the boundary layer more susceptible to travelling CFIs. In the presence of both net BFM effect and intrinsic plasma unsteady perturbations, the plasma-based BFM technique achieves transition delay with specific combinations of Reynolds number, angle of attack and wavelength of excited stationary CFI modes. The present findings provide insights into the fundamental principles of operating plasma actuators within the context of BFM control.