This paper addresses the effect of the post-process heat treatments on the microstructure and fatigue crack growth behaviour of the functionally graded (FG) laser powder bed fusion (L-PBF) Inconel 718 (IN718) superalloy. Sets of samples were additively manufactured (AM) altering the process parameters, namely the laser power, the laser scanning speed, layer thickness, hatch distance, and beam distribution function, resulting in distinctly different microstructures. Two categories of samples underwent heat treatment (HT) and hot isostatic pressing followed by HT (HIP+HT), while one category was kept in the as-processed (AP) condition to reveal the effects of the post-treatments. Additionally, to study the effect of microstructural anisotropy, samples were printed in horizontal (H) and vertical (V) building directions. To better understand the behaviour of the FG materials, non-graded (NG) L-PBF samples and wrought material were investigated as references. Significant variations in terms of porosity, grain size and elongation, crystallographic texture, and content of the strengthening precipitates or detrimental phases were found in different AM groups. The fatigue behaviour of the NG and FG materials was also studied by conducting three-point bending tests. Findings in terms of the role of different microstructures on the fatigue-crack initiation and fatigue crack growth rate are presented and discussed for all samples. The study demonstrated that heat treatments can enhance the damage tolerance of L-PBF IN718 to the level of wrought material. Interestingly, the effect of the roughness induced crack closure was found to be a function of build orientation, especially in the low stress ratio regime.@en

High strength steels are widely used for structural applications, where a combination of excellent strength and ductile-to-brittle transition (DBT) properties are required. However, such a combination of high strength and toughness can be deteriorated in the heat affected zone (HAZ) after welding. This work aims to develop a relationship between microstructure and cleavage fracture in the most brittle areas of welded S690 high strength structures: coarse-grained and intercritically reheated coarse-grained HAZ (CGHAZ and ICCGHAZ). Gleeble thermal simulations were performed to generate three microstructures: CGHAZ and ICCGHAZ at 750 and 800 °C intercritical peak temperatures. Their microstructures were characterised, and the tensile and fracture properties were investigated at − 40 °C, where cleavage is dominant. Results show that despite the larger area fraction of martensite-austenite (M-A) constituents in ICCGHAZ 750 °C, the CGHAZ is the zone with the lowest fracture toughness. Although M-A constituents are responsible for triggering fracture, their small size (less than 1 μm) results in local stress that is insufficient for fracture. Crack propagation is found to be the crucial fracture step. Consequently, the harder auto-tempered matrix of CGHAZ leads to the lowest fracture toughness. The main crack propagates transgranularly, along {100} and {110} planes, and neither the necklace structure at prior austenite grain boundaries of ICCGHAZs nor M-A constituents are observed as preferential sites for crack growth. The fracture profile shows that prior austenite grain boundaries and other high-angle grain boundaries (e.g., packet and block) with different neighbouring Bain axes can effectively divert the cleavage crack. Moreover, M − A constituents with internal sub-structures, which have high kernel average misorientation and high-angle boundaries, are observed to deflect and arrest the secondary cracks. As a result, multiple pop-ins in load-displacement curves during bending tests are observed for the investigated HAZs.@en