The bubble characteristics in a 3-D cylindrical fluidized bed have been investigated both experimentally and numerically. Experiments were performed on a 0.1 m diameter fluidized bed, with alumina oxide particles (diameter ~1 mm) as a fluidizing material. Measurements were done at a spatial resolution of 1 mm and a temporal resolution of 1000 cross-sectional images per second, using an ultrafast electron beam X-ray computed tomography (XRT) setup (Fischer and Hampel 2010). A two-fluid model using kinetic theory of granular flow (Verma et al., 2013) was used to predict the bed dynamics numerically. The equivalent bubble diameter as a function of height is in close agreement with Darton et al. (1977) and Werther (1975) correlations. The bubble size distribution predicted from simulations is broader compared to experiments. Both the bubble rise velocity and the bubble size increase with increase in excess gas velocity. The experimental measurements and simulation predictions are in fair agreement with the Hilligardt and Werther (1986) correlation.@en

Bubble characteristics in a three-dimension gas-fluidized bed (FB) have been measured using noninvasive ultrafast electron beam X-ray tomography. The measurements are compared with predictions by a two-fluid model (TFM) based on kinetic theory of granular flow. The effect of bed material (glass, alumina, and low linear density polyethylene (LLDPE), dp ~1 mm), inlet gas velocity, and initial particle bed height on the bubble behavior is investigated in a cylindrical column of 0.1-m diameter. The bubble rise velocity is determined by cross correlation of images from dual horizontal planes. The bubble characteristics depend highly upon the particle collisional properties. The bubble sizes obtained from experiments and simulations show good agreement. The LLDPE particles show high gas hold-up and higher bubble rise velocity than predicted on basis of literature correlations. The bed expansion is relatively high for LLDPE particles. The X-ray tomography and TFM results provide in-depth understanding of bubble behavior in FBs containing different granular material types.@en