In The Netherlands, existing slab-between-girder bridges with prestressed girders and thin transversely prestressed concrete decks require assessment. The punching capacity was studied in a previous series of experiments, showing a higher capacity thanks to compressive membrane action in the deck. Then, concerns were raised with regard to fatigue loading. To address this, two series of large-scale experiments were carried out, varying the number of loads (single wheel print versus double wheel print), the loading sequence (constant amplitude versus variable amplitude, and different loading sequences for variable amplitude), and the distance between the prestressing ducts. An S-N curve is developed for the assessment of slab-between-girder bridges. The experiments showed that compressive membrane actions enhances the capacity of thin transversely prestressed decks subjected to fatigue loading.@en

Previous research showed that the capacity of existing slab-between-girder bridges is larger than expected based on the punching shear capacity prescribed by the governing codes, as a result of compressive membrane action. A first series of fatigue tests confirmed that compressive membrane action also acts under cycles of loading. However, a single experiment in which first a number of cycles with a higher load level and then with a lower load level were applied, seemed to indicate that this loading sequence shortens the fatigue life. This topic was further investigated in a second series of fatigue tests with three static tests and ten fatigue tests. The parameters that were varied are the sequence of loading and the effect of a single or a double wheel print. The results show that the sequence of load levels does not influence the fatigue life. @en

In the Netherlands, the assessment of existing prestressed concrete slab-between-girder bridges has revealed that the thin, transversely prestressed slabs may be critical for static and fatigue punching when evaluated using the recently introduced Eurocodes. On the other hand, compressive membrane action increases the capacity of these slabs, and it changes the failure mode from bending to punching shear. To improve the assessment of the existing prestressed slab-between-girder bridges in the Netherlands, two 1:2 scale models of an existing bridge, i.e., the Van Brienenoord Bridge, were built in the laboratory and tested monotonically, as well as under cycles of loading. The result of these experiments revealed: (1) the static strength of the decks, which showed that compressive membrane action significantly enhanced the punching capacity, and (2) the Wöhler curve of the decks, showed that the compressive membrane action remains under fatigue loading. The experimental results could then be used in the assessment of the most critical existing slab-between-girder bridges. The outcome was that the bridge had sufficient punching capacity for static and fatigue loads and, therefore, the existing slab-between-girder bridges in the Netherlands fulfilled the code requirements for static and fatigue punching.@en

In the Netherlands, slab-between-girder bridges with prestressed girders and transversely prestressed decks in between the girders require assessment. Static testing showed that compressive membrane action increases the capacity of these structures and that the decks fail in punching shear. The next question is if compressive membrane action also increases the capacity of these decks under repeated loads. Therefore, the same half-scale bridge structure as used for the static tests was subjected to repeated loads at different fractions of the maximum static load, different loading sequences, and for single and double concentrated loads. A relationship between the load level and number of cycles at failure (S-N curve) for the assessment of these bridges is proposed, but the influence of the loading sequence was not successfully quantified yet. The conclusion of the experiments is that compressive membrane action enhances the punching capacity of transversely prestressed thin decks subjected to repeated loads. @en