There has been a long tradition in making ice structures, but the development of technical improvements for making ice buildings is a new field with just a handful of researchers. Most of the projects were realized by professors in cooperation with their students as part of their education in architecture and civil engineering. The following professors have realized ice projects in this setting: Heinz Isler realized some experiments since the 1950s; Tsutomu Kokawa created in the past three decades several ice domes in the north of Japan with a span up to 25 m; Lancelot Coar realized a number of fabric formed ice shell structures including fiberglass bars and hanging fabric as a mold for an ice shell in 2011 and in 2015 he produced an fabric-formed ice origami structure in cooperation with MIT (Caitlin Mueller) and VUB (Lars de Laet). Arno Pronk realized several ice projects such as the 2004 artificially cooled igloo, in 2014 and 2015 dome structures with an inflatable mold in Finland and in 2016–2019, an ice dome, several ice towers and a 3D printed gridshell of ice in Harbin (China) as a cooperation between the Universities of Eindhoven & Leuven (Pronk) and Harbin (Wu and Luo). In cooperation between the University of Alberta and Eindhoven two ice beams were realized during a workshop in 2020. In this paper we will present the motivation and learning experiences of students involved in learning-by-doing by realizing one large project in ice. The 2014–2016 projects were evaluated by Sanders and Overtoom; using questionnaires among the participants by mixed cultural teams under extreme conditions. By comparing the results in different situations and cultures we have found common rules for the success of those kinds of educational projects. In this paper we suggest that the synergy among students participating in one main project without a clear individual goal can be very large. The paper will present the success factors for projects to be perceived as a good learning experience.

This paper presents a detailed structural analysis of a bubble shell engineered by Heinz Isler. Through 3D scanning the geometry of this shell structure has become available to the authors. Structural analysis has not been possible before since the geometry of the shell was not available. The bubble shell was Isler’s most built type of shell. In the paperfirst the process of reverse engineering the geometry of the shell is described. Second, the effect of pre-stress in the edge beams is described. Third, the load distribution throughout the shell and the membrane behaviour relative to bending behaviour is assessed.