The potential of using atmospheric-pressure spark ablation for production of atomic clusters has been shown in the recent past. In this study we used this method to produce atomic clusters in Argon and investigated their chemical composition with an atmospheric pressure interface time-of-flight mass spectrometer (APi-TOF-MS). Both anionic and cationic silver and gold clusters were generated and characterised. The carrier gas was used directly from the gas cylinder without the application of any additional gas purification. As a result, the carrier gas stream contained trace impurities of N2, O2, and H2O, as well as radicals such as O, OH, and H and their ionized forms resulting from the plasma created by the sparks. The experimental results show that different reactivities towards oxygen and water traces can be observed depending on the number of metal atoms in the clusters, their polarity, as well as their compositions; e.g., Aun− shows less reactive behaviour towards oxygen and hydrogen compared to Agn−. The results also show that certain cluster types can be generated at large enough quantities by atmospheric-pressure spark ablation, which considering the low installation and operating cost of the technique can pave the way towards its exploitation for numerous technological applications.@en

The Alphasense optical particle counter (OPC) provides a low-cost and lightweight solution for measurements of the size and number concentration of airborne particulate matter (PM). The micro fan with which it is originally equipped cannot, however, achieve a high enough pressure differential for maintaining an adequate flow rate when connected to sampling/pretreatment aerosol lines, limiting its use for air quality monitoring. Here, we propose a simple modification on the sample flow system that enables the connection of the Alphasense OPC with sampling/pretreatment lines (e.g., dryers) commonly employed on ground observational sites, as well as its use onboard Unmanned Aerial Systems (UASs). Tests of the modified OPC using monodisperse polystyrene spherical (PS) particles having sizes between 0.8 and 2.5 μm show that both the sizing and counting performance of the modified instrument is in agreement with that of a calibrated reference OPC at concentrations from ca. 50 to 800 #/ml, which are typically encountered in the atmosphere in that size range. For particle number concentrations below or above this range, we observed a concentration-dependent counting efficiency, which can be corrected using a polynomial function derived from our measurements. Tests conducted under reduced pressure and temperature conditions demonstrate the capability of the modified OPC for accurately (i.e., within 13% deviation from the reference measurements) determining the size and number concentration of the sampled particles. The tests reported in this work show that the proposed modification can qualify the Alphasense OPC for use in both ground and aerial observations without affecting its performance, and at the same time maintaining its strongly desired characteristics (i.e., cost effectiveness and high portability).@en