The shear strength and compression properties of stiff Boom clay from Belgium at a depth of about 16.5 to 28 m were investigated by means of cone penetration and laboratory testing. The latter consisted of index classification, constant rate of strain, triaxial, direct simple shear and unconfined compression tests. The Boom clay samples exhibited strong swelling tendencies. The suction pressure was measured via different procedures and was compared to the expected in situ stress. The undrained shear strength profile determined from cone penetration tests (CPTs) was not compatible with the triaxial and direct simple shear measurements, which gave significantly lower undrained shear strength values. Micro-computed tomography (μCT) scans of the samples showed the presence of pre-existing discontinuities which may cause inconsistencies in the comparison of the laboratory test results with in situ data. The experimental data gathered in this study provide useful information for analyzing the mechanical behaviour of Boom clay at shallow depths considering that most investigations in the literature have been carried out on deep Boom clay deposits.

A series of plate loading tests on clay has been conducted in the centrifuge. The aim of the tests is to create a data set, which is freely downloadable, to validate numerical tools that account for geometrical nonlinearities. The tests include two sources of geometrical non-linearities. The first source is the reducing clay layer thickness below the plate, which causes an increase in resistance. The second source is the backflow of the clay around the tip of the plate. The backflow has a reducing effect on the plate resistance. This paper outlines four tests: two involving a wide plate and two with a small plate. Each plate geometry is investigated under both smooth and rough side model boundaries. An material point method (MPM) schematization is used for numerical analysis. The schematization and parameter selection are initially validated by comparing the MPM results against CPTu data in each test. The numerical analysis examines the impact of a finite layer thickness by analyzing various layer thicknesses. Furthermore, the analysis shows the influence of the backflow on the plate resistance by analyzing different ratios of shaft to plate width. In this study, the pore pressures below the plate and vertical and horizontal displacement fields are considered in addition to the load displacement curves. The MPM simulations are in good agreement with the centrifuge data.