Automated manufacturing of thermoplastic composites has found increased interest in aerospace applications over the past three decades because of its great potential in low-cost, high rate, repeatable production of high performance composite structures. Experimental validation is a key element in the development of structures made using this emerging technology. In this work, a mm variable-stiffness unitised integrated-stiffener out-of-autoclave thermoplastic composite wingbox is tested for a combined shear-bending-torsion induced buckling load. The wingbox is manufactured by in-situ consolidation using a laser-assisted automated tape placement technique. It is made and tested as a demonstrator section located at 85% of the wing semi-span of a B-737/A320 sized aircraft. A bespoke in-house test rig and two aluminium dummy wingboxes are also designed and manufactured for testing the wingbox assembly which spans more than 3m. Prior to testing, the wingbox assembly and the test rig were analysed using a high fidelity finite element method to minimise the failure risk due to the applied load case. The experimental test results of the wingbox are also compared with the predictions made by a numerical study performed by nonlinear finite element analysis showing less than 5% difference in load-displacement behaviour and buckling load and full agreement in predicting the buckling mode shape.

@en

This study investigates a device for in-line continuous spreading of carbon fibre/thermoplastic pre-preg tape for potential application in the Laser-Assisted Automatic Tape Placement (LATP) laminate manufacturing process. The spreading device allows variable tape width to be achieved locally during lay-up. Integration of this device in the LATP process would remove gap and overlap manufacturing defects in variable angle tow (VAT) laminates and complex curvature components. During trials different width tapes were produced using the novel spreading device. Three different width increases were investigated, viz. 15%, 30% and 45%, and were compared with as-received tape. Initial trials indicate that it is possible to achieve a tape width increase of 62%. Preliminary characterisation tests show that the spreading process does not adversely affect the properties of the tapes. Physical properties including cross-sectional area, fibre volume fraction and void content remain similar to as-received tape. Furthermore, differential scanning calorimetry data show that levels of crystallinity increase due to spreading, improving related mechanical properties.@en

A critically important consideration of stiffened structural panels is the interfacial properties between skin and stiffener. In the present study a novel implementation of laser-assisted tape placement (LATP) was used to produce a representative skin-stiffener of a wingbox from carbon fibre reinforced PEEK. First, a stiffener is manufactured using this method and subsequently the skin is attached using the same method without need for a secondary bonding process. The interfacial properties between the skin and stiffener have been characterised in terms of interlaminar shear strength (ILSS) and fracture toughness (Mode-I and Mode-II) properties. LATP laydown direction and laser power was found to influence the skin-stiffener interface Mode-I fracture toughness, but not affect the Mode-II fracture toughness. The values of ILSS and fracture toughness compare favourably with those results reported in the literature, in particular for those reported for equivalent aerospace certified CF/PEEK material (APC-2).@en