Recycling Al alloys promotes greater sustainability, as the energy required to produce recycled alloys is only about 5 % of that needed to produce the same amount of primary alloys. However, the build-up of impurities, such as Zn, during the recycling process can negatively affect the corrosion resistance of recycled alloys. The results show that the susceptibility to intergranular corrosion increased with minor additions of zinc (≤ 0.06 wt%). Zn was found to segregate along the grain boundaries, and the STEM-EDS results indicate that the Zn incorporates into the structure of Mg-Si containing grain boundary precipitates. ... Read more

Al-Mg-Si alloys are known as structural materials and are primary alloys in the automotive industry to achieve weight reduction. Shifting toward sustainability, lower energy consumption, and less CO2 emission necessitates recycling. However, the unavoidable accumulation of scrap-related impurities, e.g., Cu and Zn, during the recycling process can influence corrosion resistance of recycled alloys. The results show that Al-Mg-Si alloys containing 0.05 wt% Cu exhibit low intergranular corrosion resistance. The intergranular corrosion resistance of these alloys is notably improved by adding 0.06 wt% Zn. Low concentrations of Cu and Zn are found to strongly affect the crystal structure of hardening precipitates. ... Read more

For more than six decades, chromic acid anodizing has been the main step in the surface treatment of aluminum for adhesively bonded aircraft structures. Soon this process, known for producing a readily adherent oxide with an excellent corrosion resistance, will be banned by strict international environmental and health regulations. Replacing this traditional process in a high-demanding and high-risk industry such as aircraft construction requires an in-depth understanding of the underlying adhesion and degradation mechanisms at the oxide/resin interface resulting from alternative processes. The relationship between the anodizing conditions in sulfuric and mixtures of sulfuric and phosphoric acid electrolytes and the formation and durability of bonding under various environmental conditions was investigated. Scanning electron microscopy was used to characterize the oxide features. Selected specimens were studied with transmission electron microscopy coupled with energy-dispersive X-ray spectroscopy to measure resin concentration within structurally different porous anodic oxide layers as a function of depth. Results show that there are two critical morphological aspects for strong and durable bonding. First, a minimum pore size is pivotal for the formation of a stable interface, as reflected by the initial peel strengths. Second, the increased surface roughness of the oxide/resin interface caused by extended chemical dissolution at higher temperature and higher phosphoric acid concentration is crucial to assure bond durability under water ingress. There is, however, an upper limit to the beneficial amount of anodic dissolution above which bonds are prone for corrosive degradation. Morphology is, however, not the only prerequisite for good bonding and bond performance also depends on the oxides’ chemical composition. ... Read more