A Hybrid Magnetic Current Sensor With a Dual Differential DC Servo Loop
Amirhossein Jouyaeian (TU Delft - Electronic Instrumentation)
Q. Fan (TU Delft - Electronic Components, Technology and Materials)
Udo Ausserlechner (Infineon Technologies AG, Austria)
Mario Motz (Infineon Technologies AG, Austria)
Kofi A.A. Makinwa (TU Delft - Microelectronics)
More Info
expand_more
Other than for strictly personal use, it is not permitted to download, forward or distribute the text or part of it, without the consent of the author(s) and/or copyright holder(s), unless the work is under an open content license such as Creative Commons.
Abstract
This article presents a hybrid magnetic current sensor for contactless current measurement. Pick-up coils and Hall plates are employed to sense the high and low-frequency fields, respectively, generated by a current-carrying conductor. Due to the differentiating characteristic of the pick-up coils, a flat frequency response can then be obtained by summing the outputs of the coil and the Hall paths and passing the result through a 1st-order low-pass filter (LPF). For maximum resolution, the LPF corner frequency (2 kHz) is set such that the noise contribution of each path is equal. To suppress the coil-path offset without the use of large ac coupling capacitors, an area-efficient dual dc servo loop (D3SL) is used. This effectively suppresses the coil-path offset, resulting in a total offset of 73 μT , which is mainly dominated by the Hall path. Fabricated in a standard 0.18-μm CMOS process, the current sensor occupies 3.9 mm2 and draws 7.1 mA from a 1.8 V supply. It achieves 43 mA resolution in a 5 MHz bandwidth, which is 1.5 × better than the state-of-the-art hybrid sensors. It also achieves the lowest energy efficiency FoM (3.5 ×) among CMOS magnetic current sensors.