31.4 A Chopper-Stabilized Amplifier with -107dB IMD and 28dB Suppression of Chopper-Induced IMD
C.T. Rooijers (TU Delft - Electronic Instrumentation)
Shoubhik Karmakar (TU Delft - Electronic Instrumentation)
Yoshinori Kusuda (Analog Devices)
J.H. Huijsing (TU Delft - Electronic Instrumentation)
K.A.A. Makinwa (TU Delft - Microelectronics)
More Info
expand_more
Other than for strictly personal use, it is not permitted to download, forward or distribute the text or part of it, without the consent of the author(s) and/or copyright holder(s), unless the work is under an open content license such as Creative Commons.
Abstract
Amplifiers often employ chopping to achieve low offset and low-frequency noise. However, the interaction between the input signal and the chopper clock can cause chopper-induced intermodulation distortion (IMD) [1] -[5]. This is especially problematic for input frequencies (Fin) near even multiples of the chopping frequency (FCH), as the resulting IMD tones fold-back to low frequencies and so cannot be filtered out. In [2] -[4], spread-spectrum clocks are used to convert such tones into noise-like signals. However, this increases the noise floor and does not address the underlying problem. This paper shows that chopper-induced IMD is mainly due to amplifier delay, which results in large chopping spikes. A novel fill-in technique is proposed that mitigates these spikes, and so reduces the chopper-induced IMD. In a prototype chopper-stabilized amplifier, it reduces the chopper-induced IMD by 28dB, resulting in an IMD of -126dB for input frequencies near 4FCH (=80kHz). Similarly, it improves the chopped amplifier's two-tone IMD (79 and 80kHz) from -97dB to -107dB, thus maintaining the same IMD as the un-chopped amplifier.