Defects and morphological changes in nanothin Cu films on polycrystalline Mo analyzed by thermal helium desorption spectrometry

Venugopal, V.; Seijbel, L.J.; Thijsse, B.J.

doi:doi:10.1063/1.1925765

Defects and morphological changes in nanothin Cu films on polycrystalline Mo analyzed by thermal helium desorption spectrometry

Title

Defects and morphological changes in nanothin Cu films on polycrystalline Mo analyzed by thermal helium desorption spectrometry

Author

Venugopal, V.
Seijbel, L.J.
Thijsse, B.J.

Faculty

Mechanical, Maritime and Materials Engineering

Department

Materials Science and Engineering

Date

2005-07-26

Abstract

Thermal helium desorption spectrometry (THDS) has been used for the investigation of defects and thermal stability of thin Cu films (5–200?Å) deposited on a polycrystalline Mo substrate in ultrahigh vacuum. These films are metastable at room temperature. On heating, the films transform into islands, giving rise to a relatively broad peak in the helium desorption spectra. The temperature of this island formation is dependent on film thickness, being 417?K for 10?Å and 1100?K for a 200?Å film. The activation energy for island formation was found to be 0.3±0.1?eV for 75?Å film. Grain boundaries have a strong effect on island formation. The defect concentration in the as-deposited films is ? 5×10?4, for films thicker than 50?Å and more for thinner films. Helium release from monovacancies was identified in the case of a 200?Å film. Helium release was also seen during sublimation of the Cu film ( ? 1350?K). Overlayer experiments were used to identify helium trapped close to the film surface. An increase of the substrate temperature during deposition resulted in a film that had already formed islands. Argon-ion assistance (250?eV) during film deposition with an ion/atom ratio of ? 0.1 resulted in a significant enhancement of helium trapping in the films. The argon concentration in the films was found to be 10?3. The temperature of island formation was increased due to argon-ion assistance. The helium and argon desorption spectra are found to be similar, which is due to most of the helium becoming trapped in the defects created by the argon beam. The role of the Mo surface in affecting the defects at the film-substrate interface is investigated. The effect of variation of helium fluence and helium implantation energy is also considered. The present THDS results of Cu/poly-Mo are compared to those of Cu/Mo(100) and Cu/Mo(100) reported earlier.

Subject

copper
molybdenum
helium
discontinuous metallic thin films
surface morphology
thermally stimulated desorption
thermal stability
heat treatment
grain boundaries
vacancies (crystal)
sublimation
doping
ion beam assisted deposition
nanostructured materials