The development of a computational workflow for the semi-automated construction of patient-specific finite element models of tibial fracture fixation

The development of a computational workflow for the semi-automated construction of patient-specific finite element models of tibial fracture fixation

Moolenaar, Jet (TU Delft Mechanical, Maritime and Materials Engineering)

Tümer, N. (mentor)
Checa, Sara (mentor)
Zadpoor, A.A. (graduation committee)

Delft University of Technology

Biomedical Engineering

2023-02-27

Introduction: Tibial fracture healing complications occur frequently with reported non-union rates up to 23%. Preoperative patient-specific finite element (FE) modelling of fracture fixation may help to minimize these complications. However, developing such models requires labour-intensive work including (manual) segmentation of bones from medical images, making them unpractical for clinical applications. This study aims to establish a semi-automated workflow for the development of three-dimensional (3D) patient-specific FE models of long bone fractures based on two-dimensional (2D) X-ray images and patient characteristics.

Methods: A statistical shape model (SSM) of the tibia was developed based on computed tomography (CT) scans of subjects without tibial fractures. Using this model, shape parameters were correlated to patient characteristics, including gender, age, weight, and height of the subjects, using multilinear regression. Thereafter, strategies were developed to (1) fit the SSM of the tibia to a previously unseen fractured tibia based on two orthogonal X-rays and patient characteristics to estimate its intact 3D shape, and to (2) automatically model the fracture lines as detected on the X-rays in the intact tibia model. Using the automatically created geometries of the fractured tibia, FE models of the stabilized fracture were developed in Abaqus/CAE and used to investigate strains within the callus under post-operative loading conditions. The workflow was tested on one patient and the strains obtained from the FE models within the fracture region were compared to strains reported in the literature.

Results: An SSM of the tibia was successfully developed based on CT scans of 25 subjects (15 male, age = 60 ± 5.5; 10 female, age = 51 ± 7.1). The first five shape modes captured 90% of the total shape variation in the studied population. Significant correlations were found between the first shape mode, which described shape changes in the tibial length, and patient gender, age, weight, and height. SSM-to-patient fitting was achieved with a mean error of 0.81 mm and a maximum error of 4.22 mm. FE analysis of the stabilized fracture predicted inter-fragmentary compressive strains between 0 and 10% with a median value of 2%. Increasing the fixation working length by 13 mm, led to a 10-fold increase in the predicted median compressive strains.

Discussion and Conclusions: A workflow for the semi-automated generation of FE models of tibia fractures was successfully established. Patient-specific FE analysis results predicted strains within the fracture in a range reported for optimal bone formation. Additionally, predicted strains were highly dependent on the fixation configuration and material, most notably the fixation working length. Future work should focus on fully automating the suggested workflow and on the validation of the results. Ultimately, such a workflow could be used to formulate individualized treatment recommendations during the early pre- and post-operative phase in tibial fracture management to prevent non-union development.

bone fracture fixation
preoperative planning
osteosynthesis
computer-assisted
finite element modeling
patient-specific
Statistical Shape Model

http://resolver.tudelft.nl/uuid:36a0b472-36bf-4684-973e-0f4de1d3a323

2024-03-01

Student theses

master thesis

© 2023 Jet Moolenaar