A CMOS Dual- RC Frequency Reference With ±200-ppm Inaccuracy From -45 °C to 85 °C

This paper presents a 7-MHz CMOS RC frequency reference. It consists of a frequency-locked loop in which the output frequency of a digitally controlled oscillator (DCO) is locked to the combined phase shifts of two independent RC (Wien bridge) filters, each employing resistors with complementary temperature coefficients. The filters are driven...

A 280 μW Dynamic Zoom ADC With 120 dB DR 118 dB SNDR in 1 kHz BW

This paper presents a dynamic zoom analog-to-digital converter for use in low-bandwidth (<1 kHz) instrumentation applications. It employs a high-speed asynchronous successive approximation register (SAR) ADC that dynamically updates the references of a fully differential Δ Σ ADC. Compared to previous zoom ADCs,...

A CMOS Dual-RC frequency reference with ±250ppm inaccuracy from -45°C to 85°C

To comply with wired communication standards such as USB, SATA and PCI/PCI-E, systems-on-chip require frequency references with better than 300ppm accuracy. LC-based references achieve 100ppm accuracy [1], but suffer from high power consumption (∼20mW). Thermal diffusivity (TD) references require less power (∼2mW), at the expense of less...

A 280μW dynamic-zoom ADC with 120dB DR and 118dB SNDR in 1kHz BW

Micro-power ADCs with high linearity and dynamic range (DR) are required in several applications, such as smart sensors, biomedical imaging, and portable instrumentation. Since the signals of interest are then often small (tens of μν) and slow (<1kHz BW), such ADCs should also exhibit low offset and flicker noise. Noise-shaping SAR [1] and...

A Hybrid ADC for High Resolution: The Zoom ADC

This paper presents a dynamic zoom ADC for audio applications. It achieves 109-dB DR, 106-dB SNR, and 103-dB SNDR in a 20-kHz bandwidth, while dissipating 1.12 mW and occupying only 0.16 mm2 in 0.16-μm CMOS. This translates to state-of-the-art energy and area efficiency. In this paper, the system- and circuit-level design of the ADC will be...

Compact Thermal-Diffusivity-Based Temperature Sensors in 40-nm CMOS for SoC Thermal Monitoring

An array of temperature sensors based on the thermal diffusivity (TD) of bulk silicon has been realized in a standard 40-nm CMOS process. In each TD sensor, a highly digital voltage-controlled oscillator-based Σ Δ ADC digitizes the temperature-dependent phase shift of an electrothermal filter (ETF). A phase calibration scheme is used to...

Analysis and Design of VCO-Based Phase-Domain ΣΔ Modulators

VCO-based phase-domain ΣΔ modulators employ the combination of a voltage-controlled-oscillator (VCO) and an up/down counter to replace the analog loop filter used in conventional ΣΔ modulators. Thanks to this highly digital architecture, they can be quite compact, and are expected to shrink even further with CMOS scaling. This paper describes...

A Dynamic Zoom ADC with 109-dB DR for Audio Applications

This paper presents the first dynamic zoom ADC. Intended for audio applications, it achieves 109-dB DR, 106-dB signal-to-noise ratio, and 103-dB SNDR in a 20-kHz bandwidth, while dissipating only 1.12 mW. This translates into the state-of-the-art energy efficiency as expressed by a Schreier FoM of 181.5 dB. It also achieves the state-of-the...

A 200 μA Duty-Cycled PLL for Wireless Sensor Nodes in 65 nm CMOS

<br/><br/>

Impulse-Based Scheme for Crystal-Less ULP Radios

This study describes a method of implementing a fully integrated ultra-low-power (ULP) radio for wireless sensor networks (WSNs). This is achieved using an ad hoc modulation scheme (impulse radio), with a bandwidth of 17.7 MHz in the 2.4 GHz-ISM band and a specific medium access control (MAC) protocol, based on a duty-cycled wake-up radio and a...