OBJECTIVE: The treatment of mature biofilm in implant-associated infections (IAI) has become increasingly challenging, mainly due to the rise of antibiotic-resistant bacteria. While many antibacterial biomaterials harness their functionality through their surface properties, alternating magnetic field (AMF)-induced hyperthermia offers an approach from a fundamentally different angle. METHOD: To summarize and compare the practice of assessing AMF-induced hyperthermia in vitro and in vivo as treatment for implant-associated infections and the efficacy of this therapy, a literature search was conducted and 18 articles were selected based on relevance. RESULTS AND CONCLUSION: The studies have demonstrated that AMF-induced hyperthermia can effectively eliminate biofilms as a standalone treatment or in combination with antimicrobials. Although thermal tissue damage is an inherent concern, it can be controlled and reduced by implementing short intermittent heating patterns around 65-75ºC while still preserving antibacterial efficacy. However, clear guidelines for evaluating safety, particularly regarding thermal injury, are still lacking and should be a key focus of future work.

This study proposes a new concept for an on-demand drug releasing device intended for integration into additively manufactured (i.e., 3D printed) orthopedic implants. The system comprises a surface with conduits connected to a subsurface reservoir used for storage and on-demand release of antimicrobial agents, covered with a cap that prevents the antibacterial agents from being released until alternating magnetic field (AMF) raises the temperature of the cap, thus, releasing the stored drug. To demonstrate this concept, Ti6Al4V specimens are directly 3D printed using selective laser melting and their surface, reservoirs, and drug releasing properties are characterized. A new synthetic antimicrobial peptide, SAAP-148, is thereafter tested for its cytotoxic, osteogenic, and immunomodulatory effects at concentrations relevant for its minimal bactericidal concentration (MBC) and is compared with its natural analogue, LL-37. The results showed that AMF successfully activated the release from the 3D printed loaded samples. Both peptides demonstrated to be non-cytotoxic within the MBC levels for macrophages and preosteoblasts and did not influence their osteoimmunomodulatory behavior. The findings of this study indicate that the proposed concept is technically feasible and has the potential to be used for the development of bone implants with on-demand delivery systems to fight IAI without systemic or continuous local release of antibiotics.

Aseptic loosening of a permanent prosthesis remains one of the most common reasons for bone implant failure. To improve the fixation between implant and bone tissue as well as enhance blood vessel formation, bioactive agents are incorporated into the surface of the biomaterial. This study reviews and compares five bioactive elements (copper, magnesium, silicon, strontium, and zinc) with respect to their effect on the angiogenic behavior of endothelial cells (ECs) when incorporated on the surface of biomaterials. Moreover, it provides an overview of the state-of-the-art methodologies used for the in vitro assessment of the angiogenic properties of these elements. Two databases are searched using keywords containing ECs and copper, magnesium, silicon, strontium, and zinc. After applying the defined inclusion and exclusion criteria, 59 articles are retained for the final assessment. An overview of the angiogenic properties of five bioactive elements and the methods used for assessment of their in vitro angiogenic potential is presented. The findings show that silicon and strontium can effectively enhance osseointegration through the simultaneous promotion of both angiogenesis and osteogenesis. Therefore, their integration onto the surface of biomaterials can ultimately decrease the incidence of implant failure due to aseptic loosening.