This paper studies the dynamic stall characteristics of thick flatback and nonflatback wind turbine airfoils. Two airfoils with a maximum thickness of (Formula presented.) were studied, with trailing edge thicknesses of (Formula presented.) and (Formula presented.), respectively. The static and dynamic experimental measurements were performed in the wind tunnel using surface pressure measurements for clean and tripped airfoils at the Reynolds number of (Formula presented.) and dynamic reduced frequency ranging from (Formula presented.) to (Formula presented.). The effects of the trailing edge gap, roughness, mean angle of attack, and reduced frequency on the dynamic stall characteristics of the airfoils were investigated. The results show that increasing the trailing edge gap delays the onset of dynamic stall. However, the lift loss after the onset of dynamic stall is for the flatback airfoil higher than the sharp trailing edge airfoil. Moreover, the flatback airfoil show higher lift overshoot compared to the sharp trailing edge airfoil in the dynamic stall condition. Increasing the reduced frequency affects the dynamic behavior both airfoils differently.

This study examined the effect of vortex generators on the dynamic stall characteristics of thick wind turbine airfoils with a relative thickness of 35% and trailing edge thickness of 10% and 2%. The experiments were conducted in the TU Delft LTT wind tunnel at a Reynolds number of Re=1×10⁶ and dynamic reduced frequency ranging from 0.032 to 0.096. The study investigated the impact of various factors on the dynamic stall characteristics of the airfoils, including the vortex generator's chord position, trailing edge gap, roughness, mean angle of attack, and reduced frequency. The study found that vortex generators delay dynamic stall for thick airfoils by stabilizing the flow during the upstroke phase. However, this can increase the maximum lift overshoot, particularly with flatback airfoils, resulting in a higher drop in lift during dynamic stall. This can potentially increase the dynamic loads on a wind turbine blade due to stall-induced vibrations. The study noted a significant difference in dynamic stall behavior between flatback and non-flatback airfoils. Overall, this research provides valuable insights into the dynamic stall and flow physics characteristics of thick wind turbine airfoils using vortex generators, aiding in more accurate rotor blade design.