Integrated circuits based on wide bandgap semiconductors are considered an attractive option for meeting the demand for high-temperature electronics. Here, we report an analog-to-digital converter fabricated in a silicon carbide complementary metal-oxide-semiconductor technology now available through Europractice. The MOSFET component in this technology was measured up to 500 °C, and the key parameters, such as threshold voltage, field-effect mobility, and channel-length modulation parameters, were extracted. A 4-bit flash data converter, consisting of 266 transistors, is implemented with this technology and demonstrates correct operation up to 400 °C. Finally, the gate oxide quality is investigated by time-dependent dielectric breakdown measurements at 500 °C. A field-acceleration factor of 4.4 dec/(MV/cm) is obtained by applying the E model.

The demand for accurate temperature sensing in extreme temperatures is increasing. Traditional silicon-based integrated temperature sensors usually cannot survive above 200 °C. Many researchers have started to focus on semiconductors with a large bandgap. Among them, silicon carbide (SiC) is the most promising one. Nevertheless, most reported SiC sensors are in the form of discrete components and are not compatible with integrated electronics. In this work, we demonstrate an open 4H-SiC CMOS technology, and the fabrication steps are detailed. The temperature sensing elements in this technology, including resistors based on different implanted layers and MOSFETs, are characterized up to 600 °C. At room temperature, the resistive-based elements demonstrate large negative temperature coefficients of resistance (TCRs). With increasing temperature, the TCR starts to decrease and even becomes positive. The TCR change is due to the interplay between increasing dopant ionization rate and decreasing mobility as a function of temperature. The resistance change with temperature fits well into the Steinhart-Hart model and second-order polynomial equation. The p-type diode-connected MOSFET has a sensitivity of 4.35 mV/°C with a good linearity. The nMOS-based sensor has a maximum sensitivity of -9.24 mV/°C but a compromised linearity. The characterization of these sensing elements provides important results for potential users who will work on SiC integrated temperature sensing with this technology.

This work presents the design and characterization of an analog-to-digital converter (ADC) with silicon carbide (SiC) for sensing applications in harsh environments. The SiC-based ADC is implemented with the state-of-the-art low-voltage SiC complementary-metal-oxide-semiconductor (CMOS) technology developed by Fraunhofer IISB. Two types of ADCs, i.e., a 4-bit flash ADC and a 6-bit successive-approximation (SAR) ADC, are designed and simulated up to 300 degrees Celsius. The measurement results show that the 4-bit SiC flash ADC can operate reliably up to at least 200 degrees Celsius, which outperforms the Si counterpart regarding the maximum operating temperature.