Cooper pair splitters hold utility as a platform for investigating the entanglement of electrons in Cooper pairs, but probing splitters with voltage-biased Ohmic contacts prevents the retention of electrons from split pairs since they can escape to the drain reservoirs. We report the ability to controllably split and retain single Cooper pairs in a multi-quantum-dot device isolated from lead reservoirs, and separately demonstrate a technique for detecting the electrons emerging from a split pair. First, we identify a coherent Cooper pair splitting charge transition using dispersive gate sensing at GHz frequencies. Second, we utilize a double quantum dot as an electron parity sensor to detect parity changes resulting from electrons emerging from a superconducting island.@en

Utilizing dispersive gate sensing (DGS), we investigate the spin-orbit field (BSO) orientation in a many-electron double quantum dot (DQD) defined in an InSb nanowire. While characterizing the interdot tunnel couplings, we find the measured dispersive signal depends on the electron-charge occupancy, as well as on the amplitude and orientation of the external magnetic field. The dispersive signal is mostly insensitive to the external field orientation when a DQD is occupied by a total odd number of electrons. For a DQD occupied by a total even number of electrons, the dispersive signal is reduced when the finite external magnetic field aligns with the effective BSO orientation. This fact enables the identification of BSO orientations for different DQD electron occupancies. The BSO orientation varies drastically between charge transitions, and is generally neither perpendicular to the nanowire nor in the chip plane. Moreover, BSO is similar for pairs of transitions involving the same valence orbital, and varies between such pairs. Our work demonstrates the practicality of DGS in characterizing spin-orbit interactions in quantum dot systems, without requiring any current flow through the device. @en

Superconducting resonators enable fast characterization and readout of mesoscopic quantum devices. Finding ways to perform measurements of interest on such devices using resonators only is therefore of great practical relevance. We report an experimental investigation of an InAs nanowire multiquantum dot device by probing gigahertz resonators connected to the device. First, we demonstrate accurate extraction of the dc conductance from measurements of the high-frequency admittance. Because our technique does not rely on dc calibration, it could potentially obviate the need for dc measurements in semiconductor qubit devices. Second, we demonstrate multiplexed gate sensing and the detection of charge tunneling on microsecond timescales. The gigahertz detection of dispersive resonator shifts allows rapid acquisition of charge stability diagrams, as well as resolving charge tunneling in the device with a signal-to-noise ratio of up to 15 in 1μs. Our measurements show that gigahertz-frequency resonators may serve as a universal tool for fast tuneup and high-fidelity readout of semiconductor qubits.@en

Dispersive sensing is a powerful technique that enables scalable and high-fidelity readout of solid-state quantum bits. In particular, gate-based dispersive sensing has been proposed as the readout mechanism for future topological qubits, which can be measured by single electrons tunneling through zero-energy modes. The development of such a readout requires resolving the coherent charge tunneling amplitude from a quantum dot in a Majorana-zero-mode host system faithfully on short time scales. Here, we demonstrate rapid single-shot detection of a coherent single-electron tunneling amplitude between InAs nanowire quantum dots. We realize a sensitive dispersive detection circuit by connecting a sub-GHz, lumped-element microwave resonator to a high-lever arm gate on one of the dots. The resulting large dot-resonator coupling leads to an observed dispersive shift that is of the order of the resonator linewidth at charge degeneracy. This shift enables us to differentiate between Coulomb blockade and resonance - corresponding to the scenarios expected for qubit-state readout - with a signal-to-noise ratio exceeding 2 for an integration time of 1μs. Our result paves the way for single-shot measurements of fermion parity on microsecond time scales in topological qubits.@en

We demonstrate the use of radio-frequency (rf) resonators to measure the capacitance of nanoscale semiconducting devices in field-effect transistor configurations. The rf resonator is attached to the gate or the lead of the device. Consequently, tuning the carrier density in the conducting channel of the device affects the resonance frequency, quantitatively reflecting its capacitance. We test the measurement method on InSb and InAs nanowires at dilution-refrigerator temperatures. The measured capacitances are consistent with those inferred from the periodicity of the Coulomb blockade of quantum dots realized in the same devices. In an implementation of the resonator using an off-chip superconducting spiral inductor we find the measurement sensitivity values reaching down to 75zF/Hz at 1 kHz measurement bandwidth, and noise down to 0.45 aF at 1 Hz bandwidth. We estimate the sensitivity of the method for a number of other implementations. In particular, we predict a typical sensitivity of about 40zF/Hz at room temperature with a resonator composed of off-the-shelf components. Of several proposed applications, we demonstrate two: the capacitance measurement of several identical 80-nm-wide gates with a single resonator, and the field-effect mobility measurement of an individual nanowire with the gate capacitance measured in situ. @en

Superconducting coplanar-waveguide resonators that can operate in strong magnetic fields are important tools for a variety of high-frequency superconducting devices. Magnetic fields degrade resonator performance by creating Abrikosov vortices that cause resistive losses and frequency fluctuations or suppress the superconductivity entirely. To mitigate these effects, we investigate lithographically defined artificial defects in resonators fabricated from Nb-Ti-N superconducting films. We show that by controlling the vortex dynamics, the quality factor of resonators in perpendicular magnetic fields can be greatly enhanced. Coupled with the restriction of the device geometry to enhance the superconductors critical field, we demonstrate stable resonances that retain quality factors ≃105 at the single-photon power level in perpendicular magnetic fields up to B⊥ ≃20mT and parallel magnetic fields up to B⥠≃6T. We demonstrate the effectiveness of this technique for hybrid systems by integrating an In-Sb nanowire into a field-resilient superconducting resonator and use it to perform fast charge readout of a gate-defined double quantum dot at B=1T.@en

We report direct detection of charge tunneling between a quantum dot and a superconducting island through radio-frequency gate sensing. We are able to resolve spin-dependent quasiparticle tunneling as well as two-particle tunneling involving Cooper pairs. The quantum dot can act as an RF-only sensor to characterize the superconductor addition spectrum, enabling us to access subgap states without transport. Our results provide guidance for future dispersive parity measurements of Majorana modes, which can be realized by detecting the parity-dependent tunneling between dots and islands.@en

Circuit quantum electrodynamics has proven to be a powerful tool to probe mesoscopic effects in hybrid systems and is used in several quantum computing (QC) proposals that require a transmon qubit able to operate in strong magnetic fields. To address this we integrate monolayer graphene Josephson junctions into microwave frequency superconducting circuits to create graphene based transmons. Using dispersive microwave spectroscopy we resolve graphene's characteristic band dispersion and observe coherent electronic interference effects confirming the ballistic nature of our graphene Josephson junctions. We show that the monoatomic thickness of graphene renders the device insensitive to an applied magnetic field, allowing us to perform energy level spectroscopy of the circuit in a parallel magnetic field of 1 T, an order of magnitude higher than previous studies. These results establish graphene based superconducting circuits as a promising platform for QC and the study of mesoscopic quantum effects that appear in strong magnetic fields.@en