As the offshore energy industry begins to develop wind farms in areas of deeper water, the use of traditional foundations such as shallow foundation and driven hollow steel tube piles becomes uneconomical. The deployment of floating turbines and continued development of novel/efficient anchoring systems for these structures will be an important factor in the continued growth of the sector. This paper presents an investigation carried out as part of a proof-of-concept for a novel “bi-wing anchor”. This design will allow a plate anchor to be dropped through the water column and then penetrate the seabed under its own weight. The anchor will then be dragged causing it to embed further into the seabed and provide a greater holding capacity. This paper focuses on experimental as well as analysis of the drag embedment behaviour during the installation and pullout phases. The physical modelling investigations were carried out in a transparent clay-surrogate which enabled observation of the anchor’s orientation during installation. The predictions using analytical modelling showed good agreement with the observed behaviour at varying embedment ratios.

One of the ways to install plate anchors in deep seabed is to drop the anchor system from the sea level and allow it to initially embed in the seabed under its own weight. Further dragging would cause the anchor to rotate and embed further into the seabed. There could be difficulties of getting the anchor plate horizontal or mooring line to be perpendicular to the plate where the maximum pullout capacity could be achieved. As part of the investigations, various aspects of the plate performance were examined through centrifuge testing in which the plate orientation and pullout angles were varied. It was presumed that dynamic stability of the anchor (during field installation) can be achieved by having the plate in biwing configuration. Therefore, the performance of the biwing anchors having different spacing between the plates was also examined in the centrifuge testing program and the findings were compared with predictions obtained through finite-element modeling (FEM). Both pullout directions and the plate angles considerably influenced the pullout capacity factors. The comparison between the predicted pullout capacity using FEM and measured pullout capacity for biwing anchors at shallow embedment depths was excellent. However, the FEM-predicted pullout capacity was noticeably lower than the measured ones for deep anchors. Pullout capacity of biwing anchors at shallow embedment depth increased as the spacing between the plates S increased from 0 to 0.5B. However, there appears to be a slight reduction in the performance in deep embedment anchors. This is also reflected in FEM findings.

This paper presents data from an initial development stage of an 'umbrella anchor' concept. The anchor can be pushed into a sand deposit in a folded arrangement to reduce installation loads. When a pull-out load is applied to the mooring line, the anchor deploys to create a large embedded plate anchor. Physical modelling was carried out in a saturated sand bed with the anchor installed at depths of up to 1.6 m and loaded vertically. During installation, liquefaction was generated at the tip of the anchor to reduce the penetration resistance. This enabled the anchor to be installed quickly and accurately to a target depth. The anchor could provide pull-out resistances comparable to an anchor that has been wished-in-place at similar depths. The observed behaviour provided encouraging preliminary results and suggests that, with further development and analysis, the concept could potentially be used for commercial applications.

The large diameter monopile is a commonly used foundation concept for offshore wind turbines. The advantages of geometrical simplicity and reliable performance make it often the most attractive solution. Despite the concept’s high popularity, optimisation of the current design models can still be made. To address fundamental understanding of modelling effects in centrifuge testing of laterally loaded monopiles in sand, a large coordinated centrifuge-testing program across 11 different centrifuge centres worldwide is ongoing. This extended abstract presents the initial results of global benchmark testing.