This study applied the process-based model XBeach to predict bathymetrically controlled rip current flow occurrence, velocities and duration in the wind-sea-dominated environment of Egmond aan Zee, The Netherlands. The model is validated against data obtained during a 5-day field experiment with GPS-equipped floating drifters. Numerical model results show good agreement with data and simulate flow patterns that resemble the offshore flow through the rip channel and subsequent alongshore drift of the drifters. The average relative error of the drifter position is 0.15 and 0.19 for the cross-shore and the alongshore position, respectively. Results from the numerical experiments suggest that the rip current intensity is tidally modulated. For the period of analysis, the rips are initiated approximately 5 hours before low tide, reaching a maximum speed during low tide, and becoming inactive 3 hours after low tide. Initiation and duration of the rip current is correlated to a ratio of ∼0.55 between offshore wave height and water depth over the bar. Further experiments with the numerical model show that at Egmond, drifters that are transported offshore by the rip current are unlikely to circulate back to the shore (with only a 14% return rate). Instead, they are ejected from the surf zone and advected alongshore, dependent on the direction of the tidal current. Without wave group forcing in the model (i.e. with a stationary wave resolving approach), the model's predictability decreases, which mostly affects the prediction of the spatial flow patterns. The rip current durations can still be predicted very well, whereas the rip current magnitude is underestimated. With wind stress forcing, the model's predictive skill increases for the alongshore flow when the wind speed is relatively high, but this is not the case for low wind conditions.@en

This paper demonstrates the potential use of nearshore bathymetry estimated from video data in a coastal operational model for the Dutch Coast, which provides daily forecast of waves, water levels and (rip) currents. Two video techniques to obtain beach bathymetry from video data- Beach Wizard and CBathy are validated against jet ski surveyed bathymetry. Both methods show good agreement with surveyed data, and bathymetric features of the beach are adequately produced. To assess the applicability of video-derived bathymetry for the purpose of rip current predictions, a model is built for Egmond aan Zee in The Netherlands, in which rip current predictions based on video-derived bathymetry are compared with those based on the jetski survey. Results show that predicted maximum mean offshore-directed (rip) velocities are in good agreement when using surveyed bathymetry (reference model) and video-derived bathymetry. Finally, to address the rip current forecasting skill, this local model is forced by wave boundary conditions obtained from a larger-scale wave prediction model, in addition to the bathymetry from video. Results show that useful information can still be obtained regarding the rip currents' flow where maximum offshore-directed velocities obtained from the predictive model resemble adequately rip currents pattern in the reference model. This paper will discuss each component of the model system and the validation result on hindcasting and forecasting rip currents.@en

Rip currents are wave-induced and off-shore directed flows which occur frequently in the surf zone and can pose a serious threat to swimmers. While the behaviour of rip currents has been studied in swell-dominated environments, less is known about their characteristics in wind-sea dominated environments. This study aims to improve the knowledge on rip currents in these environments such as the Dutch coast. In a field campaign at Egmond aan Zee (The Netherlands), Lagrangian velocities in the surf zone were measured with drifter floats. An extensive dataset of rip current measurements was collected from which parameters that initiate rip currents and affect their mean flow properties were identified. Numerical simulations with XBeach aided to understand and confirm the observations made in the field. A reduction of the hydrodynamic parameters along with simplification of the bathymetry in the model allowed for identification of the governing rip current parameters, which can be the basis for a warning system.@en

Rip currents are wave-induced and off-shore directed flows which occur frequently in the surf zone and can pose a serious threat to swimmers. While the behaviour of rip currents has been studied in swell-dominated environments, less is known about their characteristics in wind-sea dominated environments. This study aims to improve the knowledge on rip currents in these environments such as the Dutch coast. In a field campaign at Egmond aan Zee (The Netherlands), Lagrangian velocities in the surf zone were measured with drifter floats. An extensive dataset of rip current measurements was collected from which parameters that initiate rip currents and affect their mean flow properties were identified. Numerical simulations with XBeach aided to understand and confirm the observations made in the field. A reduction of the hydrodynamic parameters along with simplification of the bathymetry in the model allowed for identification of the governing rip current parameters, which can be the basis for a warning system.@en