As an important consideration in the chemical industry, chemical process safety has received notable attention in China. However, catastrophic chemical accidents still occur. To better understand why accidents continue to occur, this paper presented a diagnostic analysis of 14 major chemical accidents in China from 2012 to 2022 based on VOSviewer software. The authors analysed the correlation between the accident causation and their relationship with the safety management elements. The study observed that inferior process safety culture, intentional violation (rule-breaking) of procedure, inadequate safety training, and illegal operations were the most frequent causes of accidents. These causes highlighted the prominent gaps in PSM in China in the process safety culture, compliance with standards, the conduct of operations, process safety competency, and training & performance assurance. The results based on co-occurrence analysis indicated a strong correlation between these gaps in PSM. Enterprises should pay attention to collaborative management among them. These deficiencies in the enterprise's PSM system showed that the essential defects in China's chemical industry are a poor safety culture, inadequate accident investigation, inadequate training, and a lack of chemical safety personnel. The study recommended that the chemical industry establish superior process safety culture and competency for all personnel, monitor leading and lagging process safety indicators, apply inherent safety, and practice advanced safety management concepts. We hope that the findings can provide China's perspectives and strengths for global chemical safety.@en

The chemical process industry (CPI) in China is developing rapidly with installations becoming more complicated and integrated to meet people's rising demands for chemical-related products. However, the fast-growing CPI has caused catastrophic consequences and bad social influence due to accidents occurred in the last decades, which has threatened its sustainable development. As one of the solutions, the Chinese government is promoting chemical process safety education to train interdisciplinary graduates who understand both chemical process and loss prevention, who are skilled in technology, and how to manage risk. In this paper, we reviewed the development of chemical process safety education in China by researching syllabuses of accredited undergraduate Chemical Engineering and Safety Engineering majors in higher education institutions, discussed the associated shortcomings by analyzing the current discipline construction of the newly established major Chemical Safety Engineering, including education methodologies, resources, faculties, curriculum provision, and professional accreditation. Based on the analysis results, suggestions were provided to encourage institutions to strengthen chemical process safety education, thereby inherently reducing human errors and consequently improving the safety of the entire CPI.@en

This article presents a bibliometric analysis and mapping of the Chinese process safety research, focusing on the contributions made in core process safety journals and on the influences of international collaborations and knowledge sources on the developments of this research domain. Collaboration networks, term co-occurrence networks, and co-citation network were analyzed to identify trends, patterns, and the knowledge distribution of the Chinese research on process safety. Work to data has been clustered mainly on safety of chemical processes, fire and explosion, and risk management and accidents. Chinese research contributions are concentrated in only few journals, while the corresponding intellectual base draws on the wider literature focused on understanding and modeling phenomena, and on the broader risk research literature, although to a lesser extent. While various foreign authors are highly cited by Chinese authors, only very few direct collaborations with international scholars are identified. The results are used as a basis for a discussion on future research directions and developments for the community. Increased focus on uncertainty treatment and handling of black swan events, risk evaluation and economic aspects of safety decisions, interorganizational risk management, road and maritime transport of hazardous substances, risk perception and communication, and integrated safety and security assessment, are highlighted as fruitful directions for future scholarship. It is hoped that the insights obtained from this work can facilitate new and consolidated collaborations, as well as further invigorate the Chinese process safety domain, ultimately contributing to improved safety performance of process industries in China and elsewhere.@en

Understanding seismic changes in the subsurface is important for reservoir management and health, safety and environmental (HSE) issues. Typically the changes are interpreted based on the time shifts in seismic time-lapse (4D) data, where sources are at the surface and receivers are either at the surface or in a borehole. With these types of acquisition geometry, it is more straightforward to detect and interpret changes in the overburden, close to the source and receivers, than changes in the deeper part close to the reservoir, because the time shift is accumulative along its ray path from source to receiver. We propose a new method for reconstructing the reflection responses of the overburden and the reservoir, separately, for 4D time shift analysis. This method virtually moves sources and receivers to a horizontal borehole level, which enables a more direct interpretation of the time shifts to the changes close to the borehole, instead of to the surface. A realistic field model is used to demonstrate the method, and we observe a clear discrimination of the different time shifts in the overburden and reservoir, which is not obvious in the original datasets.@en

A novel application of seismic interferometry (SI) and Marchenko imaging using both surface and borehole data is presented. A series of redatuming schemes is proposed to combine both data sets for robust deep local imaging in the presence of velocity uncertainties. The redatuming schemes create a virtual acquisition geometry where both sources and receivers lie at the horizontal borehole level, thus only a local velocity model near the borehole is needed for imaging, and erroneous velocities in the shallow area have no effect on imaging around the borehole level. By joining the advantages of SI and Marchenko imaging, a macrovelocity model is no longer required and the proposed schemes use only single-component data. Furthermore, the schemes result in a set of virtual data that have fewer spurious events and internal multiples than previous virtual source redatuming methods. Two numerical examples are shown to illustrate the workflow and to demonstrate the benefits of the method. One is a synthetic model and the other is a realistic model of a field in the North Sea. In both tests, improved local images near the boreholes are obtained using the redatumed data without accurate velocities, because the redatumed data are close to the target. @en

The Chinese central government has recognized that village-government networks are promising for the sustainable development of rural villages. Though many local governments tend to deploy various hands-on or hand-off governance tools to influence the sustainable development of village-governance networks, the number of villages successfully achieving "good governance" is still rare. Therefore, this study empirically elaborates on the application of three classic tools of governance networks, analyzing how leaders of local government and village communities influence the effectiveness of these tools. The data were collected by snowball interviews, careful observations, and documentary analysis in Xiaonan village, a representatively successful case of rural-village governance networks in China. We detected that governance tools are often inadequately used and under-development in Chinese rural-village governance networks, accompanying a strong interaction between the effectiveness of tools and leadership. Excellent leadership is necessary for a successful rural-village governance network and its scaling-up.@en

At present, the supervision mode of inland ferrying was conducted passively by mainly human analysis and judgement based on VTS and AIS, which is not favorable to reply increasingly serious situation of marine security supervision. The historical AIS data of the ferryboat was analyzed to explore its motion pattern and obtain the probability density spatial distribution of motion characteristics of location, course and speed by using the kernel density estimation. Then on this basis, the detection algorithm of the ferryboat abnormal behaviors was established for location and speed abnormity, and actual AIS data was used to verify the algorithm. Experimental results show that the proposed algorithm can accurately recognize the abnormal behaviors of the ferryboat, which is helpful to the marine supervision.@en

At present, the supervision mode of inland ferrying was conducted passively by mainly human analysis and judgement based on VTS and AIS, which is not favorable to reply increasingly serious situation of marine security supervision. The historical AIS data of the ferryboat was analyzed to explore its motion pattern and obtain the probability density spatial distribution of motion characteristics of location, course and speed by using the kernel density estimation. Then on this basis, the detection algorithm of the ferryboat abnormal behaviors was established for location and speed abnormity, and actual AIS data was used to verify the algorithm. Experimental results show that the proposed algorithm can accurately recognize the abnormal behaviors of the ferryboat, which is helpful to the marine supervision.@en

A standard procedure in processing vertical seismic profile (VSP) data is the separation of up- and downgoing wavefields. We show that these wavefields in boreholes can be retrieved using only single-component data, given that a full set of surface reflection data is also available. No medium parameters are required. The method is an application of the Marchenko method and uses a focusing wavefield. It is a wavefield that satisfies certain focusing conditions in a reference medium. We show that the method is applicable to boreholes with any orientation, and no receiver array is required. By this work, we present two contributions. One is that we investigate the effect of using only the traveltime from borehole data to form the focusing wavefield. The second is that we validates standard separation methods (PZ summation and f-k filtering) by retrieving the one-way wavefields from a completely different approach. We use the numerically modelled data from a realistic field velocity model in the North Sea. Three borehole geometries (horizontal, deviated and vertical) are tested. We discuss the practical aspects for field application in the end.@en

Multi-frequency Very Long Baseline Array (VLBA) polarimetry observation of the GHz-Peaked Spectrum (GPS) quasar OQ172 (J1445+0958) has been performed at 1.6, 2.2, 4.8, 8.3 and 15.3 GHz in 2005. Core-jet structures are detected in all bands with the jet strongly bent at about 3 mas from the core. The radio emission of the source is polarised at all five bands. We study the Faraday Rotation in the core and jet components at all five bands, and find good linear fits of Faraday Rotation in the core and jet components at 4.8 and 8.3 GHz. At these two frequencies, the Rotation Measure (RM) is ∼2000 rad m −2   in the core and ∼700 rad m −2   in the inner jet components and continues to decrease at the outer jet parts. We find that the depolarisation at 4.8 and 8.3 GHz might be caused by the internal medium in the source. We investigate consistency of the turnover spectra of VLBI components with the Synchrotron Self-Absorption (SSA) and Free-Free Absorption (FFA) models. Although these two models can not be easily distinguished due to the lack of low-frequency data, the physical parameters can be constrained for each model. We find that the large width of the [OIII] 5007   line is likely caused by a jet interaction with a Narrow Line Region (NLR) medium. The jet bending, significant RM variations, Faraday depolarisation, spectral turnover, and broad line width of [OIII] 5007   could be closely related, likely caused by the same nucleus medium, presumably NLR. @en

Multi-frequency Very Long Baseline Array (VLBA) polarimetry observation of the GHz-Peaked Spectrum (GPS) quasar OQ172 (J1445+0958) has been performed at 1.6, 2.2, 4.8, 8.3 and 15.3 GHz in 2005. Core-jet structures are detected in all bands with the jet strongly bent at about 3 mas from the core. The radio emission of the source is polarised at all five bands. We study the Faraday Rotation in the core and jet components at all five bands, and find good linear fits of Faraday Rotation in the core and jet components at 4.8 and 8.3 GHz. At these two frequencies, the Rotation Measure (RM) is ∼2000 rad m −2   in the core and ∼700 rad m −2   in the inner jet components and continues to decrease at the outer jet parts. We find that the depolarisation at 4.8 and 8.3 GHz might be caused by the internal medium in the source. We investigate consistency of the turnover spectra of VLBI components with the Synchrotron Self-Absorption (SSA) and Free-Free Absorption (FFA) models. Although these two models can not be easily distinguished due to the lack of low-frequency data, the physical parameters can be constrained for each model. We find that the large width of the [OIII] 5007   line is likely caused by a jet interaction with a Narrow Line Region (NLR) medium. The jet bending, significant RM variations, Faraday depolarisation, spectral turnover, and broad line width of [OIII] 5007   could be closely related, likely caused by the same nucleus medium, presumably NLR. @en

Multi-frequency Very Long Baseline Array (VLBA) polarimetry observation of the GHz-Peaked Spectrum (GPS) quasar OQ172 (J1445+0958) has been performed at 1.6, 2.2, 4.8, 8.3 and 15.3 GHz in 2005. Core-jet structures are detected in all bands with the jet strongly bent at about 3 mas from the core. The radio emission of the source is polarised at all five bands. We study the Faraday Rotation in the core and jet components at all five bands, and find good linear fits of Faraday Rotation in the core and jet components at 4.8 and 8.3 GHz. At these two frequencies, the Rotation Measure (RM) is ∼2000 rad m −2   in the core and ∼700 rad m −2   in the inner jet components and continues to decrease at the outer jet parts. We find that the depolarisation at 4.8 and 8.3 GHz might be caused by the internal medium in the source. We investigate consistency of the turnover spectra of VLBI components with the Synchrotron Self-Absorption (SSA) and Free-Free Absorption (FFA) models. Although these two models can not be easily distinguished due to the lack of low-frequency data, the physical parameters can be constrained for each model. We find that the large width of the [OIII] 5007   line is likely caused by a jet interaction with a Narrow Line Region (NLR) medium. The jet bending, significant RM variations, Faraday depolarisation, spectral turnover, and broad line width of [OIII] 5007   could be closely related, likely caused by the same nucleus medium, presumably NLR. @en