We calibrate the lateral mode AFM (LFM) by determining the position-sensitive photodetector (PSPD) signal dependency on the lateral tip displacement, which is analogous to the constant-compliance region in normal-force calibration. By stick-slip on stiff, amorphous surfaces (silica or glass), the lateral tip displacement is determined accurately using the feedback loop control of AFM system. The sufficiently high contact stiffness between the Si AFM tip and stiff, amorphous surfaces substantially reduces the error of PSPD signal dependency on the lateral tip displacement. No damage or modification of the AFM probe is involved and only a clean silicon or glass wafer is needed.

Dielectric relaxation spectroscopy (DRS) of poly(ε-caprolactone) with different draw ratios showed that the mobility of polymer chains in the amorphous part decreases as the draw ratio increases. The activation energy of the α process, which corresponds to the dynamic glass transition, increases upon drawing. The enlarged gap between the activation energies of the α process and the β process results in a change of continuity at the crossover between the high temperature a process and the α and β processes. At low drawing ratios the a process connects with the β process, while at the highest drawing ratio in our measurements, the a process is continuous with the α process. This is consistent with X-ray diffraction results that indicate that upon drawing the polymer chains in the amorphous part align and densify upon drawing. As the draw ratio increases, the α relaxation broadens and decreases its intensity, indicating an increasing heterogeneity. We observed slope changes in the α traces, when the temperature decreases below that at which τ_α ≈ 1 s. This may indicate the glass transition from the ‘rubbery’ state to the non-equilibrium glassy state.

This paper describes a novel method to fabricate porous graphene oxide (PGO) from GO by exposure to oxygen plasma. Compared to other methods to fabricate PGO described so far, e.g. the thermal and steam etching methods, oxygen plasma etching method is much faster. We studied the development of the porosity with exposure time using atomic force microscopy (AFM). It was found that the development of PGO upon oxygen-plasma exposure can be controlled by tapping mode AFM scanning using a Si tip. AFM tapping stalls the growth of pores upon further plasma exposure at a level that coincides with the fraction of sp² carbons in the GO starting material. We suggest that AFM tapping procedure changes the bond structure of the intermediate PGO structure, and these stabilized PGO structures cannot be further etched by oxygen plasma. This constitutes the first report of tapping AFM as a tool for local mechano-chemistry.

We analyze a near-second-order transition occurring in solutions of living polymers confined by two parallel surfaces in equilibrium with a reservoir solution. The molecular self-consistent field theory in the regime of weak adsorption or depletion is mapped to phenomenological Landau theory, where the order parameter is the average degree of polymerization or, equivalently, the normalized chain-end concentration. The distance between two surfaces at which the transition occurs scales as c2|c| where c is the correlation length of the polymer solution in the reservoir and c-1 is de Gennes adsorption length. In the second half of the paper we focus on experimentally observable features. The predicted transition can be detected experimentally by probing the living-polymer mediated disjoining potential between surfaces by means of, e.g., colloidal probe atomic force microscopy. To facilitate experimental investigations we derive simple explicit expressions for the disjoining potential for several regimes. By comparison with full numerical calculations it was verified that these are quite accurate.