Long-distance propagation of foam is one key to deep gas mobility control for enhanced oil recovery and CO₂ sequestration. It depends on two processes: convection of bubbles and foam generation at the displacement front. Prior studies with N₂ foam show the existence of a critical threshold for foam generation in terms of a minimum pressure gradient or minimum total interstitial velocity, beyond which strong-foam generation is triggered. The same mechanism controls foam propagation. There are few data for or for CO₂ foam. We extend previous studies to quantify and for CO₂ foam generation, and relate and with factors including injected quality (gas volume fraction in the fluids injected) - f_g, surfactant concentration - C_s, and permeability - K. In each experiment, steady pressure gradient, ∇p, is measured at fixed injection rate and quality, with total interstitial velocity, v_t, increasing-then-decreasing in a series of steps. The trigger for strong-foam generation features an abrupt jump in ∇p upon an increase in v_t. In most cases, the data for ∇p as a function of v_t identify three regimes: coarse foam with low ∇p, an abrupt jump in ∇p, and strong foam with high ∇p. The abrupt jump in ∇p upon foam generation demonstrates the existence of and for CO₂ foam. We further show how and scale with f_g, C_s and K. Conditions that stabilize lamellae reduce the values of the thresholds: both and increase with f_g and decrease with increasing C_s or K. Specifically, scales with f_g as (f_g)² and scales as (f_g)⁴, and both and scale with C_s as (C_s)^−0.4. The effect of K on the thresholds for foam generation is greater than the effects of f_g and C_s. Our data in artificial consolidated cores show that scales with K as K⁻² for CO₂ foam, in comparison to K⁻¹ for N₂ foam in unconsolidated sand/bead packs. More data are needed to verify the confidence of these correlations. It is encouraging that in the cores with K = 270 mD or greater is less than 0.17 bar/m (~ 0.75 psi/ft), 2 to 3 orders of magnitude less than for N₂ foam. Such low can be easily attainable throughout a formation. This suggests that: limited ∇p deep in formations is much less of a restriction for long-distance propagation of CO₂ foam than for N₂ foam. Foam propagation could still be challenging in low-K reservoirs (~ 10 bar/m for K = 27 mD). Nevertheless, formation heterogeneity and alternating slug injection of gas and liquid help foam generation and may well reduce the values of. More research is needed to predict long-distance propagation of foam under those conditions.

The fluvial river is a kind of open system that can interact with its outside environments and give response to disturbance from outside on the earth. It can adjust itself to the disturbances outside the system and reflects new characteristics in the process of reaching a new equilibrium. The TGD (Three Gorges Dam) constructed at the Yangtze River Upstream was set up to operate in 2003. And it has changed the boundary conditions of the downstream reaches and has broken the long term equilibrium of the Yangtze River system. The reaches alter the river regime to response the disturbance from the TGD. In this paper, the case study Shashi Reach is selected to analyze the variations of the river regime in a river system. The discharge is becoming smoother without large peak or lower discharge for the regulation of the reservoir. The sediment diameter becomes coarser downstream of the TGD and the sediment transport rate decreases as the sediment concentration becomes lower, in spite of the sediment erosion along the reach downstream. The thalweg moves in plane dramatically to adjust itself to reach a new equilibrium. And the topography changes a lot since there are different sediment and flow conditions. The disturbed river system is in the process of reaching a new equilibrium.

Polarisation diversity in radar remote sensing proved to be very successful in a variety of applications. Hydrometeors as raindrops or ice crystals are anisotropic radar targets giving rise to the use of polarisation diversity in weather radars. One advanced polarimetric weather radar is DLR's POLDIRAD in Oberpfaffenhofen. The huge data archive of this radar consists mainly of power measurements at diverse polarisation bases. This study investigates the possibility to apply the polarisation basis transformation directly on power measurements. As a result, empirical transfer functions for the change of the polarisation basis of radar reflectivities are derived. To check their validity they are applied to appropriate polarimetric radar data from the POLDIRAD.