This paper focuses on a new non-ideal phenomenon induced by the power supply crosstalk (PSC) of the row drive circuit in 8 T global shutter (GS) CMOS image sensors (CISs). A method to eliminate the non-ideal phenomenon is presented. Based on the circuit simulation, the relationship between the parasitic resistance and PSC is analyzed. The PSC would cause a charge leakage on the sampling hold (S/H) capacitors in the 8 T pixel, which in turn attenuates the output signal of the image sensor. Through the mathematical model of the in-pixel S/H circuit, the effect of PSC and exposure on signal attenuation is analyzed. To eliminate signal attenuation, this paper utilizes a separate power layout method that isolates the row drivers in different columns by using multiple power supplies. In contrast to the method of sharing the power supply, the proposed method can reduce the maximum power supply crosstalk noise from 1.17 V to 2.58 μV in the 2000 × 2 row drive array. Based on the 0.13 μm CMOS process, the measurement results of the 1st chip design using the typical shared power structure and the 2nd chip design using the separate power supply structure are compared. The measurement results show that the output signal of the 1st chip design is limited to about 303 ADU due to the power supply crosstalk. The saturated output signal of the 2nd chip design is 2200 ADU, which is in accordance with the theoretical signal output value (2200 ADU) when the pixel is saturated. The proposed method can effectively eliminate signal attenuation induced by the PSC, thereby improving the image quality of 8 T GS CIS.@en

To improve charge transfer efficiency (CTE) and eliminate image lag, the impact of spill back effect on image lag is studied in CMOS image sensors (CISs), particularly in high illumination condition. By establishing a mathematical model based on the thermionic emission and drift-diffusion theory, the physical mechanism of spill back effect is described. This model shows that a lower transfer gate (TG) operating voltage and a higher reset voltage of Floating Diffusion (FD) node would mitigate spill back effect. In a 0.18 μ m CMOS process, by setting that the gate voltage of transfer transistor and the reset voltage of FD is 2.8 V and 3.8 V respectively, CTE of the proposed pixel is increased to 100%. The theoretical analysis and TCAD simulation results can explain spill back effect and offer a reference for designing a high CTE pixel in high illumination CISs.@en