We developed, characterized, and verified an alignment procedure for the DESHIMA 2.0 instrument, an ultra-wide-band spectrometer operating between 200 and 400 GHz, at the ASTE telescope. To this end, we mounted the warm optics, consisting of a modified Dragonian dual reflector system, on a motor-controlled hexapod. Crucial in the alignment procedure is our sky chopper, which allows fast beam switching. It has a small entrance and exit aperture coupling to the (cold) sky, which creates a measurable signal with respect to the warm cabin environment. By scanning the instrument beam across the entrance aperture of the sky chopper using the hexapod, we found the hexapod configuration that produced the lowest signal on our detectors, implying that the beam is coupled fully to the cold sky and not the warm cabin. We first characterized the alignment procedure in the laboratory, where we used a vat containing liquid nitrogen as the cold source behind the sky chopper. Then, we applied the alignment procedure to DESHIMA 2.0 at ASTE. We found that the alignment procedure significantly improved the aperture efficiency compared with previously reported values of the aperture efficiency of DESHIMA at ASTE, which indicates the veracity of the alignment procedure.

Context. Integrated superconducting spectrometers (ISSs) for wide-band submillimeter (submm) astronomy use quasi-optical systems for coupling radiation from the telescope to the instrument. Misalignment in these systems is detrimental to the system performance. The common method of using an optical laser to align the quasi-optical components requires an accurate alignment of the laser to the submm beam from the instrument, which is not always guaranteed to a sufficient accuracy. Aims. We develop an alignment strategy for wide-band ISSs that directly uses the submm beam of the wide-band ISS. The strategy should be applicable in both telescope and laboratory environments. Moreover, the strategy should deliver similar quality of the alignment across the spectral range of the wide-band ISS. Methods. We measured the misalignment in a quasi-optical system operating at submm wavelengths using a novel phase and amplitude measurement scheme that is capable of simultaneously measuring the complex beam patterns of a direct-detecting ISS across a harmonic range of frequencies. The direct detection nature of the microwave kinetic inductance detectors in our device-under-test, DESHIMA 2.0, necessitates the use of this measurement scheme. Using geometrical optics, the measured misalignment, a mechanical hexapod, and an optimisation algorithm, we followed a numerical approach to optimise the positioning of corrective optics with respect to a given cost function. Laboratory measurements of the complex beam patterns were taken across a harmonic range between 205 and 391 GHz and were simulated through a model of the ASTE telescope in order to assess the performance of the optimisation at the ASTE telescope. Results. Laboratory measurements show that the optimised optical setup corrects for tilts and offsets of the submm beam. Moreover, we find that the simulated telescope aperture efficiency is increased across the frequency range of the ISS after the optimisation.

We have simulated and measured the beam properties of lens-antenna coupled hot electron bolometer mixers at a few supra-terahertz frequencies between 1.4 and 5.3 THz. The quasi-optical structures consist of an elliptical lens and a logarithmic spiral antenna. The model used for our simulations consists of a finite-element analysis to simulate the far-field radiation pattern of the antenna, geometrical optics to map the antenna radiation to the lens surface, and physical optics to calculate an arbitrary far field. We perform a thorough study of the beam properties, such as beam waist radius, phase center location and axial ratio by varying the diameter and extension of the lens, and misalignments of the antenna relative to the lens, at different operating frequencies. The simulation results are applied to the design and optimization of three different lenses for mixers to be operated at 1.4, 1.9, and 4.7 THz, respectively, which will be used in the heterodyne array receivers on board of NASA's balloon borne GUSTO observatory. The beam properties were verified experimentally by measuring the beam patterns in amplitude at multiple planes using a heterodyne technique. We found that the experimental results show good agreement with those from the simulations. Our work has delivered the mixers with the required beam characteristics for GUSTO.

We present a phase and amplitude beam pattern measurement technique using harmonic mixers. This allows a simultaneous multi-frequency phase sensitive characterization of a low resolution and wideband (220-420GHz) on-chip spectrometer using microwave kinetic inductance detectors. We investigate the beam quality, in particular the beam pointing and inferred telescope coupling and hence aperture efficiency. The measurements match the goal requirements for the DESHIMA-2 instrument for the ASTE telescope. The technique would be of interest for any (direct detector) spectrometer with a wide instantaneous bandwidth, particularly ones with dispersive components.

Integrated superconducting spectrometer (ISS) technology will enable ultra-wideband, integral-field spectroscopy for (sub)millimeter-wave astronomy, in particular, for uncovering the dust-obscured cosmic star formation and galaxy evolution over cosmic time. Here, we present the development of DESHIMA 2.0, an ISS for ultra-wideband spectroscopy toward high-redshift galaxies. DESHIMA 2.0 is designed to observe the 220–440 GHz band in a single shot, corresponding to a redshift range of z = 3.3–7.6 for the ionized carbon emission ([C II] 158 μ m). The first-light experiment of DESHIMA 1.0, using the 332–377 GHz band, has shown an excellent agreement among the on-sky measurements, the laboratory measurements, and the design. As a successor to DESHIMA 1.0, we plan the commissioning and the scientific observation campaign of DESHIMA 2.0 on the ASTE 10-m telescope in 2023. Ongoing upgrades for the full octave-bandwidth system include the wideband 347-channel chip design and the wideband quasi-optical system. For efficient measurements, we also develop the observation strategy using the mechanical fast sky-position chopper and the sky-noise removal technique based on a novel data-scientific approach. In the paper, we show the recent status of the upgrades and the plans for the scientific observation campaign.