This article presents the first application of a digital-intensive intrinsically linear digitally controlled class-E technique in a Doherty configuration. By careful nonlinear segmentation and multiphase RF-clocking along with overdrive-voltage control and automatic duty-cycle correction, it is shown that even the nonlinearities related to Doherty operation can be fully handled by the underlying design such that digital predistorion (DPD) can be, in principle, omitted. The nonlinearity behavior of the whole digital Doherty power amplifier (PA) is analyzed, and closed-form equations are given to predict the AM-AM and AM-phase modulation (PM) curves. In addition, time/phase mismatch between the peak and main branches and the AM and PM signals is accurately compensated. In order to achieve the maximum intrinsic linearity, two separate chips with the same architecture, but different design parameters, are fabricated as the main and peak amplifiers in 40-nm bulk CMOS. To achieve a large RF bandwidth and high passive combiner efficiency, a differential low-loss, wideband Marchand balun-based Doherty power combiner, implemented using reentrant coupled lines with independent second-harmonic control is proposed, and together with the matching network is fabricated on a two-layer PCB. The measured peak/6-dB power backoff P OUT, drain efficiency/power-added efficiency at 2.4 GHz are 17.5 dBm/12.2 dBm, 57%/52% and 36%/25% with VDD main/peak = 0.6 V/0.7 V. Measured results without using DPD show -41-dBc adjacent channel power ratio (ACPR) and -36-dB error vector magnitude (EVM) for a 16-MHz OFDM signal at 2.5 GHz. By using DPD, the measured ACPR and EVM of a 16-MHz/32-MHz OFDM signals are -52 dBc/-48 dBc and -50 dB/-48 dB, respectively.

A highly efficient and linear wideband digital polar CMOS class-E power amplifier (DPA) is presented. Using a compensated wideband Marchand balun with re-entrant coupled lines for the output matching network, more than 50% peak drain efficiency over 2.2-3GHz with 16-17dBm Pout are achieved. The linearity is significantly improved by nonlinearly sizing the DPA array along with overdrive-voltage control and concurrent multiphase RF clocking. The chip prototype is fabricated in 40nm bulk CMOS and the balun is fabricated on a two-layer PCB. Measured results show -40dBc for a 40MHz QAM signal at 2.6GHz without using any sort of DPD. The measured peak Pout, DE and PAE at 2.6GHz are 17.2dBm, 67% and 45% with VDD=0.7V.

This paper presents an advanced 2.3-2.8 GHz fully-integrated digital-intensive polar Doherty transmitter realized in 40nm standard CMOS. The proposed architecture comprises CORDIC, digital delay aligners, interpolators, digital pre-distortion (DPD) circuitry in combination with frequency-agile wideband phase modulators followed by the digital main and peak power amplifier (PA) operating in quasi-load insensitive class-E using an on-chip power combiner. At 2.5 GHz, its maximum output power is +21.4 dBm. Drain efficiency is 49.4% at peak power, and 33.7% at 6-dB power back-off. Applying DPD for a 20-MHz 64-QAM signal, the measured EVM is better than -30 dB while the average drain efficiency is 24%.